Low-loss metallic hollow waveguides coated with durable and nontoxic ZnS

Matsuura, Yuji; Miyagi, Mitsunobu
October 1992
Applied Physics Letters;10/5/1992, Vol. 61 Issue 14, p1622
Academic Journal
Presents a low-loss metallic hollow waveguide coated with zinc sulfide. Utilization of radio frequency and electroplating techniques in the fabrication of the waveguides; Demonstration of the low-loss property of the zinc sulfide coated waveguide; Derivation of the beam profile.


Related Articles

  • Pockels’ effect in polycrystalline ZnS planar waveguides. Wong, B.; Jessop, P. E.; Kitai, A. H. // Journal of Applied Physics;8/1/1991, Vol. 70 Issue 3, p1180 

    Presents a study that demonstrated the Pocket's effect in thermally evaporated polycrystaline thin films on zinc sulphide planar waveguides. Details of the experiment; Results and discussion; Conclusion.

  • Fabrication of the ZnS-ZnO composite film by sulfurizing the as-electrodeposited ZnO film. Zifeng Wang; Yongzhao Liu; Yushan Liu; Jianmin Zhang // Advanced Materials Research;2014, Issue 881-883, p909 

    The ZnS-ZnO composite film was successfully prepared by sulfidation of the as-electrodeposited ZnO film in the aqueous solution of zinc nitrate and hexamethylenetetramine. The ZnO film was electrodeposited on the substrate of indium-tin oxide (ITO) glass, and then the sodium sulfide solution was...

  • Stimulated emission of Cr2+ ions in ZnS:Cr thin-film electroluminescent structures. Vlasenko, N. A.; Oleksenko, P. F.; Mukhlyo, M. A.; Veligura, L. I.; Denisova, Z. L. // Semiconductor Physics, Quantum Electronics & Optoelectronics;2009, Vol. 12 Issue 4, p362 

    First observation of stimulated Cr2+ emission in ZnS:Cr electroluminescent (EL) impact-excited thin-film waveguide structures is reported. The structures consist of the following thin films deposited on a glass substrate: a transparent In2O3:Sn electrode, an insulator SiO2/Al2O3 layer (~270 nm),...

  • Electrodeposited ZnS Precursor Layer with Improved Electrooptical Properties for Efficient CuZnSnS Thin-Film Solar Cells. Mkawi, E.M.; Ibrahim, K.; Ali, M.K.M.; Farrukh, M.A.; Mohamed, A.S. // Journal of Electronic Materials;Oct2015, Vol. 44 Issue 10, p3380 

    Zinc sulfide (ZnS) thin films were prepared on indium tin oxide-coated glass by electrodeposition using aqueous zinc sulfate, thiourea, and ammonia solutions at 80°C. The effects of sulfurization at temperatures of 350°C, 400°C, 450°C, and 500°C on the morphological, structural,...

  • Changes induced in a ZnS:Cr-based electroluminescent waveguide structure by intrinsic near-infrared laser radiation. Vlasenko, N.; Oleksenko, P.; Mukhlyo, M.; Veligura, L. // Semiconductors;Aug2013, Vol. 47 Issue 8, p1116 

    The causes of changes that occur in a thin-film electroluminescent metal-insulator-semiconductor-insulator-metal waveguide structure based on ZnS:Cr (Cr concentration of ∼4 × 10 cm) upon lasing (λ ≈ 2.6 μm) and that induce lasing cessation are studied. It is established that...

  • Strain effect and photoluminescence of ZnS epilayers grown on GaP(100) substrates by hot-wall... Nam, Sungun; Lee, Ki-Seon; O, Byungsung; Yong Dae choi; Chang-Soo Kim // Journal of Applied Physics;7/15/1998, Vol. 84 Issue 2, p1047 

    Studies the strain effect and photoluminescence of zinc sulfide (ZnS) epilayers grown on GaP(100) substrates by hot-wall epitaxy. In-depth look at the growth and crystallinity of ZnS epilayers; Examination of the optical properties; Growth rate of ZnS epilayers on GaP substrates as a function...

  • Pulse plated zinc sulphide films and their characteristics. Murali, K. R.; Abirami, J.; Balasubramanian, T. // Journal of Materials Science: Materials in Electronics;Mar2008, Vol. 19 Issue 3, p217 

    Zinc sulphide thin films were deposited by the pulse plating technique using AR grade Zinc sulphate and sodium thiosulphate precursors. The pH of the deposition bath was adjusted to 2. The duty cycle was varied in the range of 20–60%. Total deposition time was kept constant as 60 min in...

  • Zinc sulfide based multicolor light source. Bulanyı, M. F.; Polezhaev, B. A.; Prokof’ev, T. A. // Technical Physics;Oct97, Vol. 42 Issue 10, p1229 

    The electroluminescence spectra of manganese-activated zinc sulfide single crystals have been investigated. A multicolor light source in the blue and orange regions has been fabricated on the basis of the experimental results.

  • Effect of hot-pressing temperature on the optical transmission of zinc sulfide. Xue, Liang A.; Rishi Raj // Applied Physics Letters;2/4/1991, Vol. 58 Issue 5, p441 

    Studies the effect of hot-pressing temperature on the optical transmission of zinc sulfide. Preparation of two phase mixtures of zinc sulfide; Optical properties of the two phase composites; Index of refraction.


Read the Article


Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics