TITLE

Regrowth of a thin InP surface covering layer in the Au/InP system during annealing

AUTHOR(S)
Pecz, B.; Radnoczi, G.
PUB. DATE
July 1992
SOURCE
Applied Physics Letters;7/6/1992, Vol. 61 Issue 1, p105
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Investigates the regrowth of a thin InP surface covering layer in the gold/indium phosphide (Au/InP) system during annealing. Importance of InP in high-speed and optoelectronic devices; Features of the Au/InP system; Development of the AuP phase at low temperature.
ACCESSION #
4221252

 

Related Articles

  • Influence of low-temperature annealing on the properties of Y[sub 1]Ba[sub 2]Cu[sub 3]O[sub 7-δ] thin films. Drozdov, Yu. N.; Pavlov, S. A.; Parafin, A. E. // Technical Physics Letters;Jan98, Vol. 24 Issue 1, p24 

    The influence of annealing at 180 °C on the structure, critical temperature, and electrical resistivity of Y[sub 1]Ba[sub 2]Cu[sub 3]O[sub 7-δ] thin films has been investigated. It is shown that films grown at reduced temperatures are sensitive to this annealing, which can substantially...

  • Extended-pulse excimer laser annealing of Pb(Zr1-xTix)O3 thin film on LaNiO3 electrode. Lai, S. C.; Hang-Ting Lue; Hsieh, K. Y.; Lung, S. L.; Liu, Rich; Wu, T.B.; Donohue, P. P.; Rumsby, P. // Journal of Applied Physics;9/1/2004, Vol. 96 Issue 5, p2779 

    Comparing to conventional short-pulse (<30 ns) excimer laser annealing, the extended pulse (374 ns) can provide sufficient thermal energy and time into the Pb(Zr1-xTix)O3 (PZT) thin film to complete the crystallization, whereas the bulk of the material remains at low temperature. In this study,...

  • Low-temperature formation of epitaxial Tl[sub 2]Ca[sub 2]Ba[sub 2]Cu[sub 3]O[sub 10] thin films.... Lee, W.Y.; Garrison, S.M. // Applied Physics Letters;2/10/1992, Vol. 60 Issue 6, p772 

    Analyzes the low-temperature formation of epitaxial Tl[sub 2]Ca[sub 2]Ba[sub 2]Cu[sub 3]O[sub 10] (2223) thin films in reduced O[sub 2] pressure. Techniques used for sputter deposition and post-annealing of 2223 amorphous precursor films; Requirements needed to form the 2223 films; Preparations...

  • Isotopic study of the nitrogen-related modes in N+-implanted ZnO. Artús, L.; Cuscó, R.; Alarcón-Lladó, E.; González-Díaz, G.; Mártil, I.; Jiménez, J.; Wang, B.; Callahan, M. // Applied Physics Letters;4/30/2007, Vol. 90 Issue 18, p181911 

    Micro-Raman measurements were performed to study the nitrogen-related modes in ZnO samples implanted with N+. The two stable N isotopes, 14N and 15N, were implanted. Distinct peaks at 277 and 512 cm-1 are observed irrespective of the implanted isotope, both before and after rapid thermal...

  • Influence of low temperature thermal annealing on the performance of microcrystalline silicon thin-film transistors. Chan, Kah-Yoong; Bunte, Eerke; Stiebig, Helmut; Knipp, Dietmar // Journal of Applied Physics;4/1/2007, Vol. 101 Issue 7, p074503 

    Top-gate staggered microcrystalline silicon thin-film transistors (μc-Si:H TFTs) were prepared by plasma enhanced chemical vapor deposition at temperatures below 200 °C. The μc-Si:H TFTs exhibit high effective electron mobilities (device mobilities) of up to 35 cm2/V s for long channel...

  • Role of donor defects in enhancing ferromagnetism of Cu-doped ZnO films. Li, Xiao-Li; Xu, Xiao-Hong; Quan, Zhi-Yong; Guo, Jun-Feng; Wu, Hai-Shun; Gehring, G. A. // Journal of Applied Physics;May2009, Vol. 105 Issue 10, p103914 

    Zn0.97Cu0.03O films were prepared by pulsed-laser deposition on c-cut sapphire substrates under various conditions in order to investigate the growth-dependent properties of the films. All the films exhibit room temperature ferromagnetism. Samples deposited at low temperature and low pressure...

  • Quantum size effects in Bi films grown on GaAs (110). Abu-Samak, Mahmoud // Journal of Applied Physics;Dec2008, Vol. 104 Issue 12, p123714 

    Photoemission results, obtained with a helium-discharge lamp on the Bi/GaAs(110) interface shows strong modifications in the electronic structure of the low temperature deposited Bi overlayer upon annealing to room temperature, accompanied by developing of a sharp low energy electron-diffraction...

  • Effect of annealing oxygen flow rate on the properties of vanadium oxide films deposited by reactive magnetron sputtering. Huafu Zhang; Zhiming Wu; Xuefei Wu; Yadong Jiang // Advanced Materials Research;2014, Vol. 936, p651 

    Vanadium oxide films were prepared on indium-tin oxide glass substrates at low temperature by means of reactive direct current magnetron sputtering and subsequent in-situ annealing process in pure oxygen ambient. In the process of annealing, the oxygen flow rates were varied from 0 to 15 SCCM in...

  • Low-temperature post-deposition annealing investigation for 3D charge trap flash memory by Kelvin probe force microscopy. Huo, Zongliang; Jin, Lei; Han, Yulong; Li, Xinkai; Ye, Tianchun; Liu, Ming // Applied Physics A: Materials Science & Processing;Jan2015, Vol. 118 Issue 1, p1 

    The influence of post-deposition annealing (PDA) temperature condition on charge distribution behavior of HfO thin films was systematically investigated by various-temperature Kelvin probe force microscopy technology. Contact potential difference profiles demonstrated that charge storage...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics