TITLE

Complete microcrystalline p-i-n solar cell--Crystallline or amorphous cell behavior?

AUTHOR(S)
Meier, J.; Fluckiger, R.
PUB. DATE
August 1994
SOURCE
Applied Physics Letters;8/15/1994, Vol. 65 Issue 7, p860
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Develops a microcrystalline silicon p-i-n solar cell. Application of the high frequency glow discharge method; Behavior of the crystalline cell; Relationship between carrier transport and diffusion; Properties of solar cells.
ACCESSION #
4218128

 

Related Articles

  • 20% efficiency silicon solar cells. Blakers, A. W.; Green, M. A. // Applied Physics Letters;1/20/1986, Vol. 48 Issue 3, p215 

    Further improvements in crystalline silicon solar cell performance have been obtained by combining the high levels of surface recombination control demonstrated in earlier passivated emitter solar cells with an improved optical approach. This approach involves the use of microgrooved surfaces...

  • 18% efficient intrinsically passivated laser-processed silicon solar cells. Wood, R. F.; Westbrook, R. D.; Jellison, G. E. // Applied Physics Letters;1/12/1987, Vol. 50 Issue 2, p107 

    It is demonstrated that single-crystal silicon solar cells with efficiencies greater than 18% AM1.5 can be fabricated by glow discharge implantation and pulsed excimer laser annealing. A unique characteristic of these cells is that the surfaces are passivated intrinsically to give open circuit...

  • Polycrystalline silicon solar cells with a mechanically formed texturization. Bender, H.; Szlufcik, J.; Nussbaumer, H.; Palmers, G.; Evrard, O.; Nijs, J.; Mertens, R.; Bucher, E.; Willeke, G. // Applied Physics Letters;6/7/1993, Vol. 62 Issue 23, p2941 

    Presents the preparation of polycrystalline silicon solar cells using a conventional diffusion and screen printed metallization method. Application of a dicing saw and beveled blades for the V-groove formation; Comparison with the standard nongrooved structure.

  • Gettering and hydrogen passivation of edge-defined film-fed grown multicrystalline silicon solar.... Sana, Peyman; Rohatgi, Ajeet; Kalejs, Juris P.; Bell, Richard O. // Applied Physics Letters;1/3/1994, Vol. 64 Issue 1, p97 

    Focuses on the gettering and hydrogen passivation of edged-defined film-fed grown multicrystalline silicon solar cells. Preparation of aluminum gettering; Performance of oxide passivation; Impact of the forming gas anneal on cell efficiency.

  • High minority carrier lifetime in phosphorus-gettered multicrystalline silicon. Cuevas, Andres; Stocks, Matthew // Applied Physics Letters;2/24/1997, Vol. 70 Issue 8, p1017 

    Examines the electronic quality of multicrystalline silicon produced by directional solidification. Use of contactless photoconductance instrument to monitor the carrier lifetime; Minority carrier lifetime of the material after phosphorous diffusion gettering treatment; Efficacy of silicon as a...

  • Sharp band edge photoluminescence of high-purity CuInS[sub 2] single crystals. Yoshino, Kenji; Ikari, Tetsuo; Shirakata, Sho; Miyake, Hideto; Hiramatsu, Kazumasa // Applied Physics Letters;2/5/2001, Vol. 78 Issue 6, p742 

    Temperature-dependent photoluminescence measurements were carried out between 8 and 300 K on CuInS[sub 2] single crystals grown by a traveling heater method. Ten distinct peaks were present in the near-band edge region. Four unknown peaks, observed at 8 K, were found to be due to bound exciton...

  • Copper passivation of dislocations in silicon. Lee, Jae-Gwang; Morrison, S. Roy // Journal of Applied Physics;12/15/1988, Vol. 64 Issue 12, p6679 

    Presents information on a study which introduced copper to passivate the defects in silicon materials and improve the efficiencies of solar cells. Examples of silicon materials that have a number of defects which degrade electrical properties; Methodology of the study; Results and discussion.

  • FLASHBACK>10 YEARS AGO.  // Electronic Design;5/27/2002, Vol. 50 Issue 11, p26 

    Recalls an article from the May 28, 1992 issue of 'Electronic Design' journal concerning the energy efficiency of polycrystalline-silicon solar cell. Practical application of photovoltaic technology; Factors that contributed to the efficiency of the solar cell; Solar cell fabrication process.

  • Enhancement of diffusion length of pregettered multicrystalline silicon solar cells by hydrogen.... Sivoththaman, S.; Rodot, M.; Muller, J.C.; Hartiti, B.; Ghannam, M.; Elgamel, H.E.; Nijs, J.; Sarti, D. // Applied Physics Letters;6/14/1993, Vol. 62 Issue 24, p3172 

    Examines the fabrication of pregettered multicrystalline silicon solar cells by hydrogen ion implantation. Enhancement of electron diffusion length and short circuit current; Use of thin wafers for solar cell fabrication; Factors affecting cell performance.

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics