High angular tolerant color filter using subwavelength grating

Byoung-Ho Cheong; Prudnikov, O. N.; Eunhyoung Cho; Hae-Sung Kim; Jaeho Yu; Young-Sang Cho; Hwan-Young Choi; Sung Tae Shin
May 2009
Applied Physics Letters;5/25/2009, Vol. 94 Issue 21, p213104
Academic Journal
A reflective color filter based on a two-dimensional subwavelength grating is proposed. The filter has been designed by performing numerical simulations and has been fabricated on 5×5 mm2 quartz glass using electron beam lithography. The grating color filter shows reflectance of 74% and spectral width of about 80 nm. Furthermore, it has good angular tolerance, up to ±45°, for unpolarized incident light. By analyzing the reflectance spectral distributions in the band diagram, we found that high angular tolerance is achieved due to the high refractive index contrast of grating structures.


Related Articles

  • Prediction of the Bandgap of a Core-Shell Microsphere via Light Intensity Fluctuations. Moon Kyu Choi; Youngjin Choi // International Journal of Photoenergy;2011, Special section p1 

    It has been experimentally observed that in the case of microspheres irradiated by light, the absorption wavelength shift occurs, known as the blueshift, with changing shell materials (i.e., by decreasing the refractive index of the shell). In the present investigation, we want to demonstrate it...

  • Numerical Design Methods of Nanostructure Array for Nanobiosensing. Shaoli Zhu; Wei Zhou; Gi-Ho Park; Erping Li // Plasmonics;Sep2010, Vol. 5 Issue 3, p267 

    Numerical methods are very important for designing nanodevices since localized surface plasmon resonance is sensitive to the geometric parameters. Especially, as for nano-biosensor, the proper choice of design tool is very critical in terms of the accuracy and simulation time. In this paper, we...

  • Chalcogenide glass square photonic crystal fibre with large negative dispersion and high non-linearity.  // Australian Journal of Electrical & Electronic Engineering;2014, Vol. 11 Issue 1, following p136 

    We propose a square structure, square lattice photonic crystal fibre (PCF) with square air-holes in its cladding. We consider chalcogenide (As2Se3) glass as the material of PCF. Chalcogenide glass has a large refractive index and high non-linearity compared to silica glass. A large negative...

  • Negative refraction with high transmission at visible and near-infrared wavelengths. Changchun Yan; Yiping Cui; Qiong Wang; Shichuang Zhuo; Jianxin Li // Applied Physics Letters;6/16/2008, Vol. 92 Issue 24, p241108 

    A left-handed material, a metal waveguide with arrays of metal rods within it, is investigated in this letter. The simulation results have shown that the refractive indices are negative between 512 and 898 nm, while the negative-index band with high transmission ranges roughly from 672 to 798...

  • Validation of an analytical model of Si-ring resonators for designing a 1 × 8 multiplexer in SCISSOR configuration. Chauveau, Clément; Labeye, Pierre; Fedeli, Jean-Marc; Hazart, Jérôme; Blaize, Sylvain; Lerondel, Gilles // Optical & Quantum Electronics;Oct2012, Vol. 44 Issue 12/13, p541 

    We numerically simulate chromatic and thermal dispersion in ring-resonator-based filters and validate the model with experimental data. A low-loss 1 × 8 multiplexer based on SCISSOR structure was designed with a bandwidth of 200GHz at −3 dB and a crosstalk better than −13.5 dB...

  • NUMEREICAL ANALYSIS OF FOUR WAVE MIXING AND EXTRACTION OF DISPERSION PARAMETERS OF THE FIBRE. Sugumaran, S.; Goswami, Sabyasachi; Palsania, Saurabh; Raj, Arun; Arulmozhivarman, P. // International Journal of Engineering & Technology (0975-4024);Apr/May2013, Vol. 5 Issue 2, p1129 

    Four wave mixing generally occurs when two or more different wavelengths from two or more sources are launched into the fibre, resulting in a new wavelength known as idler (different from the given wavelengths). Here in this paper the efficiency of the generation of idler and the power of idler...

  • Inscription of high contrast volume Bragg gratings in fused silica with femtosecond laser pulses. Voigtländer, Christian; Richter, Daniel; Thomas, Jens; Tünnermann, Andreas; Nolte, Stefan // Applied Physics A: Materials Science & Processing;Jan2011, Vol. 102 Issue 1, p35 

    We present volume Bragg gratings (VBGs) with a period of 1.075 μm inscribed in fused silica using a femtosecond laser and a phase mask. The femtosecond-inscribed VBGs can be used as reflecting elements with reflectivities of about 80% for a 1-mm-long grating. Due to the non-sinusoidal...

  • Modification of Simplified Modal Method for Subwavelength Triangular Grating with Very High Efficiency. Bin Wang; Yihui Wu; Peng Hao; Wenchao Zhou // PIERS Proceedings;Aug2014, p2074 

    A modification of simplified modal method (MSMM) is presented to calculate the transmission efficiencies of subwavelength fused-silica grating. In order to consider the reflection of grating, which is neglected in simplified modal method (SMM). Then the grating region is divided into N thin...

  • Simulation of Long Period Fibre Gratings and Applications. Baptista, Fábio D.; Guerreiro, Ariel; Gomes, Luís A.; Caldas, Paulo // AIP Conference Proceedings;2015, Vol. 1648 Issue 1, p1 

    Long-period gratings is class of fiber gratings, in which the period of the refractive index modulation is such that it satisfies a phase matching condition between the fundamental core mode and forward propagating cladding modes of an optical fiber. Many applications in optical communications...


Read the Article


Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics