TITLE

Analysis of efficiency characteristics of green phosphorescent organic light-emitting devices

AUTHOR(S)
Ji-hwan Yoon; Il-soo Park
PUB. DATE
November 2008
SOURCE
Applied Physics Letters;11/10/2008, Vol. 93 Issue 19, p193303
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Efficiency characteristics of green phosphorescent organic light-emitting devices (PHOLEDs) with different host materials and device structures were investigated by examining the luminance efficiency-current density curves and electroluminescence spectra. The efficiency of PHOLEDs at low current density as well as at high current density was greatly affected by energy levels and carrier transport properties of the host and hole/electron transporting materials. The devices exhibited high initial luminance efficiency when hole-electron recombination was well confined in the emitting layer (EML). Efficiency roll off with increasing current density was observed as hole-electron recombination and charge balance in EML deteriorated with current density.
ACCESSION #
35514295

 

Related Articles

  • High peak luminance of molecularly dye-doped organic light-emitting diodes under intense voltage pulses. Wei, B.; Ichikawa, M.; Furukawa, K.; Koyama, T.; Taniguchi, Y. // Journal of Applied Physics;8/15/2005, Vol. 98 Issue 4, p044506 

    The performance and efficiency of molecularly doped organic light-emitting devices (OLEDs) using voltage pulses have been investigated. The maximum current density and peak luminance have been found to depend on the pulse duration and device size, which was attributed to the heat effect in...

  • Demonstration of a semipolar [formula] InGaN/GaN green light emitting diode. Sharma, R.; Pattison, P. M.; Masui, H.; Farrell, R. M.; Baker, T. J.; Haskell, B. A.; Wu, F.; DenBaars, S. P.; Speck, J. S.; Nakamura, S. // Applied Physics Letters;12/5/2005, Vol. 87 Issue 23, p231110 

    We demonstrate the growth and fabrication of a semipolar (1013) InGaN/GaN green (∼525 nm) light emitting diode (LED). The fabricated devices demonstrated a low turn-on voltage of 3.2 V and a series resistance of 14.3 Ω. Electroluminescence measurements on the semipolar LED yielded a...

  • Improving light output power of InGaN-based light emitting diodes with pattern-nanoporous p-type GaN:Mg surfaces. Chung Chieh Yang; Chia Feng Lin; Chun Min Lin; Cheng Chien Chang; Kuei Ting Chen; Jui Fen Chien; Chung Ying Chang // Applied Physics Letters;11/17/2008, Vol. 93 Issue 20, p203103 

    InGaN-based light emitting diodes (LEDs) with a top pattern-nanoporous p-type GaN:Mg surface were fabricated by using a photoelectrochemical (PEC) process. The peak wavelengths of electroluminescence (EL) and operating voltages were measured as 461.2 nm (3.1 V), 459.6 nm (9.2 V), and 460.1 nm...

  • Effect of pressure in the growth reactor on the properties of the active region in the InGaN/GaN light-emitting diodes. Lundin, W. V.; Zavarin, E. E.; Sinitsyn, M. A.; Sakharov, A. V.; Usov, S. O.; Nikolaev, A. E.; Davydov, D. V.; Cherkashin, N. A.; Tsatsulnikov, A. F. // Semiconductors;Jan2010, Vol. 44 Issue 1, p123 

    Effect of pressure in the reactor in the case of growth of active regions in the InGaN/GaN light-emitting diodes by the method of vapor-phase epitaxy from metalorganic compounds on their electroluminescent and structural properties has been studied. It is shown that, as pressure is increased,...

  • Trends and Tradeoffs in Powering LED Luminaires. Weir, Bernie // LED Journal;Nov/Dec2008, Vol. 3 Issue 6, p8 

    The article deals with trends and factors to consider in power schemes for light emitting diode luminaires. LED arrangement is mentioned as an important step to consider to achieve the required output level and achieve uniform brightness. Regulatory considerations related to voltage output level...

  • Setting the Mood in Solid State Lighting. Keene, Mike // ECN: Electronic Component News;Sep2009, Vol. 53 Issue 10, p25 

    The article offers information on the light emitting diodes (LED)-based solid state lighting (SSL) systems. It is stated that the SSL systems have the capability to tune the chromaticity of light emitted from a luminaire. It is also stated that the systems can be configured to emit white light...

  • ILLUMINATING EVIDENCE.  // Electronics World;Jun2008, Vol. 114 Issue 1866, p20 

    The article analyses the challenges for the user to overcome before completing a design with power LEDs, particularly when it comes to determining the relationship between drive current, thermal management and effective lifetime. It describes the design benefits of using power LED to replace...

  • High-efficiency stacked white organic light-emitting diodes. Lee, Tae-Woo; Noh, Taeyong; Choi, Byoung-Ki; Kim, Myeong-Suk; Shin, Dong Woo; Kido, Junji // Applied Physics Letters;1/28/2008, Vol. 92 Issue 4, p043301 

    We report efficient tandem white organic light-emitting diodes (WOLEDs) by using bathocuproine:Cs2CO3/MoO3 as an effective interconnecting layer. We utilized two primary colors of sky blue and orange fluorescent emitters to obtain efficient white electroluminescence. Although single WOLEDs using...

  • Red, Green and 1.54 μm Emissions from an Er-doped n-ZnO/p-Si Light Emitting Diode. Harako, S.; Yokoyama, S.; Ide, K.; Komuro, S.; Zhao, X. // AIP Conference Proceedings;2007, Vol. 893 Issue 1, p1427 

    Er-doped ZnO/Si hetero-junctions have been formed by laser ablating an Er-contained ZnO target onto p-Si (100) substrates. Light emitting diodes fabricated by using these samples exhibit bright green, red and 1.54 μm emissions under reverse current injections at room temperature. It is...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics