TITLE

Extraordinary midinfrared transmission of rectangular coaxial nanoaperture arrays

AUTHOR(S)
Yanik, Ahmet Ali; Wang, Xihua; Erramilli, Shyamsunder; Hong, Mi K.; Altug, Hatice
PUB. DATE
August 2008
SOURCE
Applied Physics Letters;8/25/2008, Vol. 93 Issue 8, p081104
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
We analyze the extraordinary transmission effect in the periodic and random nanoaperture arrays in optically thick metal films. Experimental studies are combined with simulations to show that extraordinary transmission effect at midinfrared wavelengths is enhanced when the decaying waveguide mode of a single nanoaperture couples through the collective surface plasmon excitations created through periodicity. Transmission characteristics of the individual nanoapertures are investigated by randomizing the apertures. By comparing rectangular to coaxial rectangular nanoapertures, both of which support TE01-like decaying waveguide modes, we study the effect of nanoaperture geometry on the efficiency of the transmission.
ACCESSION #
34198867

 

Related Articles

  • Injection locking of leaky-wave coupled resonant optical waveguide arrays. Jansen, M.; Botez, D.; Mawst, L.J.; Roth, T.J.; Yang, J.J.; Ou, S.S.; Hayashida, P.; Dozal, L.A. // Applied Physics Letters;2/8/1993, Vol. 62 Issue 6, p547 

    Demonstrates the injection locking of mutually coupled resonant optical waveguide arrays. Significance of the external injection on single longitudinal operation; Enhancement of phase-locking of the coupled arrays; Distribution of the injected signal via-leaky wave coupling.

  • Bi12(GaxBi1-x)O19.5 optical waveguides grown by pulsed laser deposition. Alfonso, J. E.; Martín, M. J.; Mendiola, J.; Ruiz, A.; Zaldo, C.; da Silva, M. F.; Soares, J. C. // Journal of Applied Physics;6/1/1996, Vol. 79 Issue 11, p8210 

    Presents information on a study that deposited Bi[sub12](Ga[subx]Bi[sub1 x)O[sub19.5] films with cationic stoichiometry close to x=0.5 by pulse laser deposition. Experimental techniques; Experimental results and discussion; Conclusion.

  • Preparation and optical waveguide property of metal alkoxide solution-derived Pb(Zr0.5Ti0.5)O3 thick films. Hu, S.H.; Meng, X.J.; Hu, G.J.; Hu, J.H.; Dal, N.; Xu, L.; Liu, L.Y.; Li, D.X. // Applied Physics Letters;5/3/2004, Vol. 84 Issue 18, p3609 

    Pb(Zr0.5Ti0.5)O3 films with thickness of about 1.5 and 3.7 μm have been deposited on single-crystal SrTiO3 substrate by a sol-gel process from nonhydrolyzed metal alkoxide precursor. X-ray diffraction shows that the films exhibit a single perovskite phase with (001)-preferred orientation....

  • All-optical modulator is capable of terahertz speeds. Hochberg, Michael // Laser Focus World;Nov2006, Vol. 42 Issue 11, p11 

    The article claims that intensity modulation at frequencies in excess of 1 terahertz could be obtained by directly measuring time-domain intensity modulation at 10 GHz as demonstrated by the researchers at the California Institute of Technology. It explains that integrating the optical polymer...

  • Simulation software helps craft waveguides. Florjanczyk, Miroslaw // Laser Focus World;Aug96, Vol. 32 Issue 8, pS11 

    Describes optoelectronics simulation software packages for designing waveguides. Development of high-speed fiber optic transmission systems to satisfy the growing demand of the telecommunications industry; Importance of flexibility; Beam-propagation methods.

  • Excitonic blue luminescence from p-LaCuOSe/n-InGaZn5O8 light-emitting diode at room temperature. Hiramatsu, Hidenori; Ueda, Kazushige; Ohta, Hiromichi; Kamiya, Toshio; Hirano, Masahiro; Hosono, Hideo // Applied Physics Letters;11/21/2005, Vol. 87 Issue 21, p211107 

    A hetero p/n junction diode was fabricated by laminating an amorphous n-type InGaZn5O8 layer to a p-type LaCuOSe film epitaxially grown on a MgO (001) substrate. It exhibited a relatively sharp blue electroluminescence (EL) that peaked at ∼430 nm at room temperature when a forward bias...

  • Hybrid optical bistability based on voltage-controlled changes of persistent spectral holes. Hartmannsgruber, N.; Maier, Max // Applied Physics Letters;4/15/1991, Vol. 58 Issue 15, p1585 

    Examines a novel hybrid optical bistable device which is based on voltage-controlled changes of a persistent spectral hole. Transmitted laser power versus incident laser power; Probing laser frequency as a function of the applied voltage; Other functions served by the hybrid optical bistable...

  • Formation of a wedge-shaped element on an end face of a microstrip optical waveguide designed to minimize loss when coupling with an optical fiber. Balya, V.; Denisyuk, I. // Optics & Spectroscopy;Oct2015, Vol. 119 Issue 4, p724 

    We have investigated a method for forming microstrip optical waveguides of variable cross section designed for coupling a planar waveguide with an optical fiber. The method is based on the use of combined reactive-ion etching of polymer cladding and photoresist. It is shown that butt expansions...

  • Design and Fabrication of BaTiO3 Crystal Thin-Film Waveguides. ZHANG Jing; FU Xiu-hua; YANG Fei; GUO Li-jun; ZHOU Jian-hong; LIU Dong-mei; SUN De-gui // Key Engineering Materials;2014, Vol. 609-610, p201 

    BaTiO3 crystal film has the very high electro-optic effect, so it has important research value for thin film waveguide electro-optic modulators. In this work, BPM software is used to simulate the single-mode condition of ridge waveguide at first, then BaTiO3 film waveguide structure is designed...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics