TITLE

Effect of ZnO addition on properties of cordierite-based glass-ceramics

AUTHOR(S)
Guo-hua Chen
PUB. DATE
December 2007
SOURCE
Journal of Materials Science: Materials in Electronics;Dec2007, Vol. 18 Issue 12, p1253
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
The influences of addition of ZnO on sintering, crystallization behavior and properties of cordierite-based glass-ceramics were investigated. Results show that with increasing ZnO content, the batch melting temperature, glass transition temperature and crystallization temperature all decrease. Addition of ZnO can greatly improve the sinterability of the glass powders and alter the type of the crystalline phases. Addition of 1.5 wt% ZnO seems to be reasonable. Thermal expansion coefficients (TCEs) of samples increase with increasing ZnO contents. The density was found to be an important factor affecting the dielectric loss of the samples. Dielectric constant and TCEs of the sintered bulk samples were found to depend on their relative densities and crystalline phases. The samples doped with 1.5–3.0 wt% ZnO sintered at 950 °C has a low dielectric constant (5.0–5.2), a low dielectric loss (≤0.0018) and a low thermal expansion coefficient (3.6–4.8 × 10−6 K−1), which are promising electronic packaging materials.
ACCESSION #
26515502

 

Related Articles

  • Dynamical heterogeneities below the glass transition. Vollmayr-Lee, K.; Kob, W.; Binder, K.; Zippelius, A. // Journal of Chemical Physics;3/22/2002, Vol. 116 Issue 12, p5158 

    We present molecular dynamics simulations of a binary Lennard-Jones mixture at temperatures below the kinetic glass transition. The 'mobility' of a particle is characterized by the amplitude of its fluctuation around its average position. The 5% particles with the largest/smallest mean amplitude...

  • Glass transformation temperature and stability of tellurite glasses. El-Mallawany, Raouf // Journal of Materials Research;Feb2003, Vol. 18 Issue 2, p402 

    Presents a study which measured the glass transformation and onset crystallization temperatures of tellurite glasses. Experimental techniques; Results and discussion; Conclusion.

  • Thermophysical property determination of high temperature alloys by thermal analysis. Saari, H.; Seo, D. Y.; Blumm, J.; Beddoes, J. // Journal of Thermal Analysis & Calorimetry;2003, Vol. 73 Issue 1, p381 

    Differential scanning calorimetric measurements to determine solidus and liquidus temperatures and latent heat of fusion of two high temperature materials, PWA1484 and an experimental gamma titanium aluminide alloy, are presented. The solidus and liquidus temperatures of PWA1484 are 1340 and...

  • Quantification of amorphous content in maltitol by. Lappalainen, Minna; Pitkänen, Ilkka // Journal of Thermal Analysis & Calorimetry;May2006, Vol. 84 Issue 2, p345 

    A method was developed for the quantification of low levels of amorphous content in maltitol with StepScan DSC. The method was based on the fact that the change of specific heat at the glass transition is linearly proportional to the amorphous content. The influence of different measurement...

  • Nonexponential relaxation and fragility in a model system and in supercooled liquids. Halpern, V. // Journal of Chemical Physics;6/7/2006, Vol. 124 Issue 21, p214508 

    Among the outstanding problems in the theory of supercooled liquids are the reasons for the rapid increase in their viscosity and relaxation times as the temperature is lowered towards the glass transition temperature Tg, the nonexponential time dependence of the relaxation, and the possible...

  • The Prigogine-Defay ratio revisited. Schmelzer, Jürn W. P.; Gutzow, Ivan // Journal of Chemical Physics;11/14/2006, Vol. 125 Issue 18, p184511 

    One of the basic characteristics of the glass transition, the Prigogine-Defay ratio, connecting jumps of the thermal expansion coefficient, isothermal compressibility, and isobaric specific heat capacity in vitrification is rederived in the framework of the thermodynamics of irreversible...

  • Pressure effect of glass transition temperature in Zr[sub 46.8]Ti[sub 8.2]Cu[sub 7.5]Ni[sub 10]Be[sub 27.5] bulk metallic glass. Jiang, J.Z.; Roseker, W.; Sikorski, M.; Cao, Q.P.; Xu, F. // Applied Physics Letters;3/15/2004, Vol. 84 Issue 11, p1871 

    Pressure effects on glass transition temperature and supercooled liquid region of a Zr[sub 46.8]Ti[sub 8.2]Cu[sub 7.5]Ni[sub 10]Be[sub 27.5] bulk glass have been investigated by performing in situ high-temperature and high-pressure x-ray powder diffraction measurements using synchrotron...

  • Electronic rule for formation of glassy alloys. Fukuhara, Mikio; Takahashi, Masae; Kawazoe, Yoshiyuki; Inoue, Akihisa // Applied Physics Letters;2/12/2007, Vol. 90 Issue 7, p073114 

    The glass transition temperature Tg of 100 kinds of glassy alloys can be expressed as a function of their valence electron concentration (VEC): Tg=131VEC+57 for metal/metal bonding type and Tg=-236VEC+2375 for metal/metalloid bonding one. The electron valences of the constituent elements of the...

  • Thermal and elastic properties of Cu–Zr–Be bulk metallic glass forming alloys. Duan, Gang; Lind, Mary Laura; De Blauwe, Katrien; Wiest, Aaron; Johnson, William L. // Applied Physics Letters;5/21/2007, Vol. 90 Issue 21, p211901 

    The compositional dependence of thermal and elastic properties of Cu–Zr–Be ternary bulk metallic glass forming alloys was systematically studied. There exists a linear relationship between the glass transition temperature Tg and the total Zr concentration. G decreases linearly with...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics