TITLE

Molecularly imprinted microspheres and nanospheres for di(2-ethylhexyl)phthalate prepared by precipitation polymerization

AUTHOR(S)
Jia-Ping Lai; Min-Li Yang; Niessner, Reinhard; Knopp, Dietmar
PUB. DATE
September 2007
SOURCE
Analytical & Bioanalytical Chemistry;Sep2007, Vol. 389 Issue 2, p405
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Molecularly imprinted microspheres (MIMs, >3 μm) and nanospheres (MINs, ≈450 nm) for the environmental endocrine disruptor di(2-ethylhexyl)phthalate (DEHP) were prepared by a precipitation polymerization (PP) procedure. The effect of the dispersive solvents acetonitrile (ACN) and cyclohexane (CH), the cross-linkers ethylene glycol dimethacrylate (EDMA) and trimethylpropane trimethacrylate (TRIM), and the template on particle size and morphology of polymers was investigated in detail by scanning electron microscopy (SEM) and BET adsorption isotherm determination. When used as HPLC stationary phase, the microspheres exhibited strong affinity for the template DEHP with an imprint factor ( IF) higher than 8.0 in ACN/water (60:40, v/v) as mobile phase. Furthermore, baseline separation of DEHP from benzyl butyl phthalate (BBP) and dibutyl phthalate (DBP) could be achieved. In contrast, no or only poor separation could be observed with non-imprinted polymeric polymers (NIPs) or imprinted bulk polymers (MIB), respectively. Similarly, the obtained MINs exhibited an imprinting effect in pure ACN, i.e. the bond amount of DEHP was significantly higher compared to NIPs, as was shown in rebinding experiments. Besides their use as an HPLC stationary phase, MIMs might further be applicable for SPE sample cleanup, while MINs could be used as a recognition layer on sensor surfaces. [Figure not available: see fulltext.]
ACCESSION #
26340072

 

Related Articles

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics