TITLE

Comparison of Cu—Ce—Zr and Cu—Zn—Al mixed oxide catalysts for water-gas shift

AUTHOR(S)
Huber, Florian; Meland, Hilde; Rønning, Magnus; Venvik, Hilde; Holmen, Anders
PUB. DATE
November 2007
SOURCE
Topics in Catalysis;Nov2007, Vol. 45 Issue 1-4, p101
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Cu–Zn–Al and Cu–Ce–Zr mixed oxide catalysts were prepared by two different methods, co-precipitation and flame spray pyrolysis. The performance of the catalysts was evaluated using the water-gas shift reaction with and without CO2 and H2 added to the feed. Cu–Ce–Zr catalysts are found not to be superior to Cu–Zn–Al catalysts in terms of initial activity and short-term stability. Their apparent activation energy appears to be less affected by increased concentrations of CO2 and H2.
ACCESSION #
26161883

 

Related Articles

  • Liquid-Phase Selective Hydrogenation of 1-Heptyne over Pd/TiO2 Catalyst Synthesized by One-Step Flame Spray Pyrolysis. Mekasuwandumrong, Okorn; Phothakwanpracha, Songphon; Jongsomjit, Bunjerd; Shotipruk, Artiwan; Panpranot, Joongjai // Catalysis Letters;May2010, Vol. 136 Issue 1/2, p164 

    The Pd/TiO2 nanoparticles synthesized by one-step flame spray pyrolysis (FSP) with Pd loadings 0.5–10 wt% showed good catalytic performances in the liquid-phase selective hydrogenation of 1-heptyne. Higher selectivities to 1-heptene at complete conversion of 1-heptyne were obtained on the...

  • Method for precisely analyzing the stoichiometry of NaxCoO2-type superconductor material. Acker, Jörg; Krabbes, Gernot // Analytical & Bioanalytical Chemistry;Dec2005, Vol. 383 Issue 7/8, p1075 

    An analytical procedure for precisely determining the stoichiometry of NaxCoO2-type superconductor material is presented. Sodium and cobalt contents, ranging between 3.5 and 11 mg L−1 and 18 and 32 mg L−1, respectively, were measured simultaneously using CID–ICP–OES....

  • Abstraction of D adsorbed on Pt(111) surfaces with gaseous H atoms. Wehner, S.; Kuppers, J. // Journal of Chemical Physics;2/22/1998, Vol. 108 Issue 8, p3353 

    Examines the influence of gaseous hydrogen at deuterium covered platinum(111) surfaces at 85 Kelvin leading to the formation of gaseous HD and D[sub 2] products. Measurement of kinetics of formation of gaseous HD and D[sub 2] products; Observation of HD and D[sub 2] rate steps; Calibration of...

  • Determination of the Elemental Composition of Hydrocarbon Mixtures by Gas Chromatography with Atomic Emission Detection: Increasing the Accuracy. Chernetsova, E.; Revelskii, A.; Durst, D.; Revelskii, I. // Journal of Analytical Chemistry;Sep2005, Vol. 60 Issue 9, p855 

    In this work, the accuracy of the ratio of the numbers of carbon and hydrogen atoms ( nC/ nH) determined in the molecules of the components of aliphatic hydrocarbon mixtures by gas chromatography with atomic emission detection (GC-AED) is studied as a function of the oxygen concentration in...

  • Electrochemical Properties of Nano-sized Li4Ti5O12 Powders Prepared by Flame Spray Pyrolysis. Jung Hyun Kim; Yun Chan Kang // International Journal of Electrochemical Science;Mar2013, Vol. 8 Issue 3, p3379 

    Nanosized Li4Ti5O12 powders are prepared from a spray solution with a 15 % excess of lithium using a flame spray pyrolysis process. The mean particle size of the precursor powders is 23 nm. The Li4Ti5O12 powders obtained after post-treatment at 700°C have small amounts of rutile TiO2...

  • Sensing Characteristics of Flame-Spray-Made Pt/ZnO Thick Films as H2 Gas Sensor. Tamaekong, Nittaya; Liewhiran, Chaikarn; Wisitsoraat, Anurat; Phanichphant, Sukon // Sensors (14248220);2009, Vol. 9 Issue 9, p6652 

    Hydrogen sensing of thick films of nanoparticles of pristine, 0.2, 1.0 and 2.0 atomic percentage of Pt concentration doped ZnO were investigated. ZnO nanoparticles doped with 0.2-2.0 at.% Pt were successfully produced in a single step by flame spray pyrolysis (FSP) technique using zinc...

  • Dielectric structure pyrotechnic initiator realized by integrating Ti/CuO-based reactive multilayer films. Zhu, Peng; Shen, Ruiqi; Fiadosenka, N. N.; Ye, Yinghua; Hu, Yan // Journal of Applied Physics;Apr2011, Vol. 109 Issue 8, p084523 

    A dielectric structure pyrotechnic initiator was proposed and the initiator samples were designed and realized by integrating Ti/CuO-based reactive multilayer films on ceramic substrate. The dielectric structure consists of essentially two titanium films separated by a copper oxide (CuO) film,...

  • Liquid flame spray for generating metal and metal oxide nanoparticle test aerosol. Mäkelä, J. M.; Aromaa, M.; Rostedt, A.; Krinke, T. J.; Janka, K.; Marjamäki, M.; Keskinen, J. // Human & Experimental Toxicology;Jun/Jul2009, Vol. 28 Issue 6/7, p421 

    A flame-based method for generating nanoparticles with production rate in the order of g/min is presented to be used in a variety of applied studies concerning nanoparticle measurements and toxicological tests. In this study, ferric oxide, titanium dioxide, and silver nanoparticles were produced...

  • Self-assembled In0.22Ga0.78As quantum dots grown on metamorphic GaAs/Ge/SixGe1-x/Si substrate. Hsieh, Y. C.; Chang, E. Y.; Luo, G. L.; Chen, S. H.; Biswas, Dhrubes; Wang, S. Y.; Chang, C. Y. // Journal of Applied Physics;9/15/2006, Vol. 100 Issue 6, p064502 

    Self-assembled In0.22Ga0.78As quantum dots (QDs) grown on Si substrate with Ge/SiGe as buffer layer grown by metal organic vapor phase epitaxy were investigated. Transmission electron microscopy and atomic force microscopy images were used to observe the size and space distribution of the...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics