TITLE

Dye sensitized CO2 reduction over pure and platinized TiO2

AUTHOR(S)
Ozcan, O.; Yukruk, F.; Akkaya, E.; Uner, D.
PUB. DATE
September 2007
SOURCE
Topics in Catalysis;Sep2007, Vol. 44 Issue 4, p523
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
TiO2 thin and thick films promoted with platinum and organic sensitizers including novel perylene diimide dyes (PDI) were prepared and tested for carbon dioxide reduction with water under visible light. TiO2 films were prepared by a dip coating sol–gel technique. Pt was incorporated on TiO2 surface by wet impregnation [Pt(on).TiO2], or in the TiO2 film [Pt(in).TiO2] by adding the precursor in the sol. When tris (2,2′-bipyridyl) ruthenium(II) chloride hexahydrate was used as sensitizer, in addition to visible light activity towards methane production, H2 evolution was also observed. Perylene diimide derivatives used in this study have shown light harvesting capability similar to the tris (2,2′-bipyridyl) ruthenium(II) chloride hexahydrate.
ACCESSION #
25882685

 

Related Articles

  • Processing factor dependence of resistivity parameters of ruthenate-based thick film resistors... Crosbie, Gary M.; Johnson, F.; Trela, W. // Journal of Applied Physics;9/1/1998, Vol. 84 Issue 5, p2913 

    Focuses on ruthenate-based thick film resistors. Microstructure development in thick film resistors; Information on the two-phase resistance model; Information pertaining to the manufacture of the resistors.

  • Thick-Film Carbon Dioxide Sensor via Anodic Adsorbate Stripping Technique and Its Structural Dependence. Photinon, Kanokorn; Shih-Han Wang; Chung-Chiun Liu // Sensors (14248220);2009, Vol. 9 Issue 9, p7203 

    A three-electrode based CO2 sensor was fabricated using thick-film technology. The performance of this sensor was further enhanced by incorporating platinum nanoparticles onto the working electrode surface. An eight-fold increase in the signal output was obtained from the electrode with the...

  • Infrared spectroscopy study of adsorption and coadsorption of carbon monoxide and hydrogen on Ru/Al[sub 2]0[sub 3]. Todorova, Silvia Zh.; Kadinov, Georgi B. // Research on Chemical Intermediates;2002, Vol. 28 Issue 4, p291 

    IR spectroscopy was used to study CO adsorption and coadsorption with H[sub 2] on 5% Ru/Al[sub 2]O[sub 3]. By variation of sample pretreatment, CO pressures, contact time and temperature several surface species were identified: mono� and multicarbonyl species formed with ruthenium in...

  • Low-frequency 1/f noise of RuO2-glass thick resistive films. Kolek, A.; Stadler, A. W.; Ptak, P.; Zawislak, Z.; Mleczko, K.; Szałanski, P.; Żak, D. // Journal of Applied Physics;Nov2007, Vol. 102 Issue 10, p103718 

    Measurements of low-frequency noise in thick-film resistors at low temperatures are reported. Films were prepared in a standard “high temperature” process: 20 nm sized RuO2 powder was mixed with 0.5 μm granular lead–borosilicate glass and organic solvent to give a paste,...

  • Low-temperature organometallic chemical vapor deposition of platinum. Chen, Yea-jer; Kaesz, Herbert D.; Thridandam, Hareesh; Hicks, Robert F. // Applied Physics Letters;10/24/1988, Vol. 53 Issue 17, p1591 

    Impurity-free, polycrystalline films of platinum have been grown by the decomposition of cyclopentadienyl platinum trimethyl, CpPtMe3, in hydrogen and a noble gas over silicon or glass substrates heated to 180 °C. The films contain less than 1 at. % of oxygen and carbon, and no other...

  • Vibrational excitation in the CO2 product of the oxidation of CO on platinum: Coverage dependence and implications on reaction dynamics. Brown, L. S.; Bernasek, S. L. // Journal of Chemical Physics;2/15/1985, Vol. 82 Issue 4, p2110 

    Vibrational energy distributions in CO2 molecules formed in the catalytic oxidation of CO on platinum have been measured by using a variety of filtering techniques to analyze infrared chemiluminescent emission. For surface temperatures in the range of 650–1100 K the product molecules were...

  • Patterning of fine particles by means of supercritical CO2. Huang, J.; Moriyoshi, T.; Manabe, H. // Journal of Materials Science;Mar2006, Vol. 41 Issue 5, p1605 

    A new method for positioning fine particles on surfaces has been developed. Supercritical CO2-assisted printing (SCAP) was utilized to spray and deposit the prepared particles on solid substrates. By means of masks, regular arrays of the particles were successfully created in designed patterns....

  • Determination of Oxygen by Means of a Biogas and Gas -- Interference Study Using an Optical Tris (4,7-Diphenyl-1,10-Phenanthroline) Ruthenium(II) Dichloride Complex Sensor. Brglez, Polonca; Holobar, Andrej; Pivec, Aleksandra; Belšak, Nataša; Kolar, Mitja // Acta Chimica Slovenica;2012, Vol. 59 Issue 1, p50 

    Biogas is a mixture of gases produced by anaerobic fermentation where biomass or animal waste is decomposed and methane and carbon dioxide are mainly released. Biogas also has a very high moisture content (up to 80%), temperatures of around 60 °C, high pressure, and can contain other gases...

  • Electrocatalytic Reduction of Carbon Dioxide: Let the Molecules Do the Work. Kang, Peng; Chen, Zuofeng; Brookhart, Maurice; Meyer, Thomas // Topics in Catalysis;Feb2015, Vol. 58 Issue 1, p30 

    This review summarizes the development of electrochemical CO reduction catalysts in the UNC Energy Frontier Research Center for Solar Fuels. Two strategies for converting CO to CO or formate have been explored. In one, polypyridyl complexes of Ru(II) have been used to reduce CO to CO in...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics