TITLE

ZigBee competition-winner announced

PUB. DATE
February 2007
SOURCE
Electronics Weekly;2/21/2007, Issue 2276, p6
SOURCE TYPE
Trade Publication
DOC. TYPE
Article
ABSTRACT
The article focuses on the winners of a competition to design an electronic gadget, organized by the journal. The journal asked the readers to design a mains-fed power supply for a 3V ZigBee node. Paul Riley of the company Inovex was declared as the winner of the competition. Riley designed a 0.47μF capacitor which acts as an imaginary impedance and dissipates zero power. Chris Coffin of Cambridge-based Richmond Management Services was declared as the runner-up of the competition.
ACCESSION #
24316949

 

Related Articles

  • Components for Medical Electronics.  // ECN: Electronic Component News;Nov2001 Part 1 of 2, Vol. 45 Issue 13, p26 

    Features several medical electronics from various companies. Introduction of Mini-Motor Pot Combination, a petontiometer with digital circuits gearhead from JDK Controls; Release of the HOW100, a 100 watts and single output power supply from Absopulse Electronics; Specification of the...

  • Give Your Digital System A Power Boost. Capps, Charles P. // Electronic Design;11/11/2002, Vol. 50 Issue 24, p69 

    Focuses on the design of decoupling capacitor and a chip decoupling capacitor. Processes involved in designing a decoupling capacitor; Power distribution; Procedure in determining where on the board to place the capacitor; Cost benefits of a well-designed power-distribution system.

  • Speaking truth to power. Schweber, Bill // EDN;4/29/2004, Vol. 49 Issue 9, p26 

    This article discusses matters concerning the electronics industry as of April 29, 2004. The typical rack-mount board has about 30 separate power nets. Each net sources a different combination of nominal supply voltage, accuracy, and regulation; these nominal voltages in some case differ by...

  • A NOVEL POWER COMBINING NETWORK FOR DOHERTY AMPLIFIERS. Jeong, Hyeong Tae; Kim, Chul Dong; Chang, Ik Soo // Microwave Journal;Jul2004, Vol. 47 Issue 7, p94 

    This article proposes a new type of power network combining network for a Doherty amplifier based on the use of short transmission lines and lumped capacitors. Compared with the conventional combining network, which consists of λ/4 transmission lines, this approach permits a reduced size. The...

  • Minimize noise in power-supply measurements. Giudice, John Lo // Test & Measurement World;Oct2011, Vol. 31 Issue 9, p20 

    The article focuses on the application of an oscilloscope probe in eliminating noise in power-supply measurements. To eliminate excess noise, it suggests to connect the oscilloscope ground lead to the probe tip and move it around. It recommends the use of a multilayer stacked ceramic capacitor...

  • Take steps to reduce antiresonance in decoupling. Travis, Bill // EDN;4/15/2004, Vol. 49 Issue 8, p70 

    To maintain power integrity on personal computer boards, designers need multiple capacitors to decouple the power-distribution system. A typical configuration might comprise five capacitors connected in parallel between the power and the ground traces or planes. To provide broadband decoupling...

  • Quickly discharge power-supply capacitors. Woodward, Stephen // EDN Europe;Jul2001, Vol. 46 Issue 7, p70 

    Discusses the circuit of a quickly discharge capacitor in an electric power supply design. Pulse-handling capability of the resistors used; Value of the resulting energy hemorrhage; Dissipation of the energy of the pulse generator.

  • RELIABLE POWER INTEGRITY ANALYSIS USING MATLAB. FIZEŞAN, Raul T. // Acta Technica Napocensis. Electronica-Telecomunicatii;2013, Vol. 54 Issue 1, p19 

    In Power Distribution Network (PDN) design of high-speed systems appears to be contradictory design philosophies, component selection and layout rules. A not properly designed power distribution increases the supply rail noise, but this impacts the system's performance in statistical manners,...

  • SAG/SWELL MIGRATION USING MULTI CONVERTER UNIFIED POWER QUALITY CONDITIONER. Ram, I. Sai; Amarnadh, J.; Kumar, K. K. Vasishta // International Journal of Advances in Engineering & Technology;Nov2011, Vol. 1 Issue 5, p437 

    This paper presents a new unified power-quality conditioning system (MC-UPQC), capable of simultaneous compensation for voltage and current in multibus/multifeeder systems. In this configuration, one shunt voltage-source converter (shunt VSC) and two or more series VSCs exist. The system can be...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics