TITLE

CaCu3Ti4O12/CaTiO3 composite dielectrics: Ba/Pb-free dielectric ceramics with high dielectric constants

AUTHOR(S)
Kobayashi, W.; Terasaki, I.
PUB. DATE
July 2005
SOURCE
Applied Physics Letters;7/18/2005, Vol. 87 Issue 3, p032902
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
We have measured dielectric properties of Ca1+xCu3-xTi4O12 (x=0, 0.1, 0.5, 1, 1.5, 2, 2.9 and 3), and have found that Ca2Cu2Ti4O12 (a composite of CaCu3Ti4O12 and CaTiO3) exhibits a high dielectric constant of 1800 with a low dissipation factor of 0.02 below 100 kHz from 220 to 300 K. These are comparable to (or even better than) those of the Pb/Ba-based ceramics, which could be attributed to a barrier layer of CaTiO3 on the surface of the CaCu3Ti4O12 grains. The composite dielectric ceramics reported here are environmentally benign as they do not contain Ba/Pb.
ACCESSION #
18008230

 

Related Articles

  • Synthesis and characterization of pseudo-ternary Pb(Fe1/2Nb1/2)O3-PbZrO3-PbTiO3 ferroelectric ceramics via a B-site oxide mixing route. Bijun Fang; Yuejin Shan; Keitaro Tezuka; Imoto, Hideo // Journal of Materials Science;Dec2005, Vol. 40 Issue 24, p6445 

    Perovskite phase formation and dielectric/ferroelectric properties of the pseudo-ternary Pb(Fe1/2Nb1/2)O3-PbZrO3-PbTiO3 (PFN-PZ-PT) ferroelectric ceramics have been investigated as promising materials for multi-layer ceramic capacitors. Complete solid solution with pure perovskite phase can be...

  • Incipient ferroelectricity and microwave dielectric resonance properties of CaCu2.85Mn0.15Ti4O12 ceramics. Li, Ming; Feteira, Antonio; Sinclair, Derek C.; West, Anthony R. // Applied Physics Letters;9/24/2007, Vol. 91 Issue 13, p132911 

    Mn-doped CaCu3Ti4O12 ceramics with nominal composition CaCu2.85Mn0.15Ti4O12 (CCMTO) have been prepared and their radio- and micro-wave dielectric properties established. At 300 K, dense CCMTO ceramics have appreciable grain resistivity, ∼20 MΩ cm, and exhibit microwave dielectric...

  • Electrical hetero-structure of NdSrTiO ceramic for energy storage applications. Shen, Zong-Yang; Luo, Wen-Qin; Li, Yue-Ming; Hu, Qi-Guo; Wang, Zhu-Mei; Gu, Xing-Yong // Journal of Materials Science: Materials in Electronics;Feb2013, Vol. 24 Issue 2, p607 

    Both high dielectric constant and high bulk resistance was required to meet high energy storage density in high-voltage ceramic capacitors. In this paper, NdSrTiO (NSTO) ceramic with pure tetragonal perovskite structure was prepared by solid state reaction route. Dielectric response of NSTO...

  • Electrocoloration and oxygen vacancy mobility of BaTiO3. Yoo, H.-I.; Chang, M.-W.; Oh, T.-S.; Lee, C.-E.; Becker, K. D. // Journal of Applied Physics;Nov2007, Vol. 102 Issue 9, p093701 

    The electrical-insulation degradation of BaTiO3 is now of growing interest as the BaTiO3-based dielectric layers of multilayer ceramic capacitors are getting thinner to submicron thicknesses. The degradation is understood to be due to the electrotransport of oxygen vacancies and may be monitored...

  • Identification of quality parameters for barium titanate powder. Kris’ko, L.; Dudchik, G.; Bashkirov, L. // Glass & Ceramics;Nov2005, Vol. 62 Issue 11/12, p361 

    The authors describe the results of developing methods for determining some quality parameters of barium titanate powder, which is the main component in some ceramics that are used to produce capacitors. The degree of transformation of ZnO and BaTiO3, the volume density of sintered powder, the...

  • New High-K Set by Single-Layer Capacitor.  // American Ceramic Society Bulletin;Aug2006, Vol. 85 Issue 8, p4 

    The article introduces the Ultra Maxi series from AVX Corp. in Myrtle Beach, South Carolina. These single-layer ceramic capacitors claim a record high dielectric constant at 60,000 with X7R characteristics. It provides an ideal solution for broadband bypass applications where high performance...

  • Synthesis and properties of layered perovskite compounds. Bormanis, K.; Dambekalne, M.; Kalvane, A.; Burkhanov, A. // Physics of the Solid State;Jun2006, Vol. 48 Issue 6, p1155 

    Bi2A n − 1 B n O3 n + 3 ceramics are fabricated where A and B are ions of Ti, W, Pb, Nb, and Mo. The process of synthesis is studied, and the changes in the charge mass and volume during sintering are determined. The ceramic production process is optimized. The dielectric properties of...

  • Characterizing xBa(Mg1/3Ta2/3)O3+(1-x)Ba(Mg1/3Nb2/3)O3 microwave ceramics using extended x-ray absorption fine structure method. Chang, P.-J.; Chia, C.-T.; Lin, I.-N.; Lee, J.-F.; Lin, C. M.; Wu, K. T. // Applied Physics Letters;6/12/2006, Vol. 88 Issue 24, p242907 

    The structures of TaO6 and NbO6 oxygen octahedra in xBa(Mg1/3Ta2/3)O3+(1-x)Ba(Mg1/3Nb2/3)O3 perovskite ceramics with x=0, 0.25, 0.50, 0.75, and 1.0 were investigated by the extended x-ray absorption fine structure method. The decline in the microwave dielectric constant as x increases is caused...

  • Dielectric and complex impedance analysis of SrNbTiO ceramic with perovskite-like structure. Li, Chunchun; Wei, Xiaoyong; Fang, Liang // Journal of Materials Science: Materials in Electronics;Nov2015, Vol. 26 Issue 11, p8714 

    Dense SrNbTiO ceramic was prepared by a solid state reaction route. XRD and SEM results revealed the formation of single phase with perovskite-like structure and space group Pnnm at room temperature. Three sets of dielectric peaks were observed through dielectric measurement. A phase transition...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics