TITLE

Wetting of Solids by Aqueous Solutions of Surfactant Binary Mixtures: 1. Wetting of Low-Energy Surfaces

AUTHOR(S)
Bogdanova, Yu. G.; Dolzhikova, V. D.; Summ, B. D.
PUB. DATE
May 2003
SOURCE
Colloid Journal;May/Jun2003, Vol. 65 Issue 3, p284
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Wetting of low-energy surfaces (polymers, hydrophobized glass) by the aqueous solutions of binary mixtures of nonionic (Triton X-100) and cationic (cetyltrimethylammonium bromide) surfactants at the molar fraction of cationic surfactant α = 0.2, 0.5, and 0.8 was studied in the wide concentration range. It was shown that the contact angles of mixed solutions at low-energy surfaces could be predicted on the basis of surface tension isotherms. Concentration ranges of wetting synergism were determined.
ACCESSION #
16822044

 

Related Articles

  • Wetting of Solids by Aqueous Solutions of Surfactant Binary Mixtures: 2. Wetting of High-Energy Surface. Bogdanova, Yu. G.; Dolzhikova, V. D.; Summ, B. D. // Colloid Journal;May/Jun2003, Vol. 65 Issue 3, p290 

    Wetting of glass by aqueous solutions of binary mixtures of cationic and nonionic surfactants was studied in the range of overall concentrations c0 = 10–8–10–2 M at the molar fraction of cationic surfactant α = 0.2, 0.5, and 0.8. It was established that the character of...

  • Scale Factor upon the Grain Boundary Wetting in Polycrystals. Traskine, V.; Volovitch, P.; Protsenko, P.; Kucherinenko, Ya.; Skvortsova, Z. // Colloid Journal;May2005, Vol. 67 Issue 3, p363 

    The intergrain penetration of wetting liquids (water and gallium) is studied with polycrystalline samples of NaCl and zinc, respectively. A strong effect of a scale factor is found. The quantitative correlation between the results of simulation and the data of physical experiments is established...

  • Comparison of five commonly used thin-layer moisture transfer models in fitting the re-wetting data of barley. Basunia, M. A. // Agricultural Engineering International: CIGR Journal;Dec2013, Vol. 15 Issue 4, p228 

    Five commonly cited thin-layer rewetting models, including Page, Diffusion, Approximate form of diffusion, Exponential, and Polynomial were compared for their abilities to the fit the experimental re-wetting data of barley based on the root mean square error (RMSE) and mean relative error (MRE)...

  • Reentrant wetting transition on surfactant solution surfaces. Cheng, Y.; Ye, X.; Huang, X. D.; Ma, H. R. // Journal of Chemical Physics;10/28/2006, Vol. 125 Issue 16, p164709 

    The wetting of polydimethylsiloxane oil drops on the surfaces of anionic surfactant sodium dodecylsulfate solutions is studied systematically by changing the bulk surfactant concentration. The wetting state changes from complete wetting to pseudopartial wetting at 0.3 cmc (critical micelle...

  • Nonionic Surfactants in Textile Processing. Sabia, Angelo J. // Textile Chemist & Colorist;Aug80, Vol. 12 Issue 8, p22 

    Types, end-uses and critical properties of nonionic surfactants are reviewed. Critical micelle concentration, wetting, cloud point and compositional variations are all factors that affect surfactant behavior and must be considered in choice of a surfactant for a given end-use.

  • Surface and grain boundary wetting of Fe based solids by molten Pb and Pb-Bi eutectic. Protsenko, P.; Eustathopoulos, N. // Journal of Materials Science;May2005, Vol. 40 Issue 9/10, p2383 

    Surface and grain boundary wetting and penetration of pure Fe and a martensitic steel by Pb and Pb-Bi eutectic alloys were studied by the sessile drop and dispensed drop techniques at different temperatures (400-900°C) and times (up to 30 h). By using two different atmospheres-high vacuum and...

  • Development and Investigation of an Apparatus for Determining the Wetting of Quartz Sand. Evdokimov, S.; Galachieva, S.; Puzin, V.; Evdokimov, V.; Tebloeva, D.; Maslakov, M.; Antipov, K. // Glass & Ceramics;Jan2016, Vol. 72 Issue 9/10, p323 

    An apparatus for determining the wettability of quartz sand was developed. It was shown that as the temperature increases, the surface wettability of the minerals present in the glass quartz sand increases owing to a reduction of the slippage of the liquid along the solid surface and, in...

  • Effects of lateral diffusion on morphology and dynamics of a microscopic lattice-gas model of pulsed electrodeposition. Frank, Stefan; Roberts, Daniel E.; Rikvold, Per Arne // Journal of Chemical Physics;2/8/2005, Vol. 122 Issue 6, pN.PAG 

    The influence of nearest-neighbor diffusion on the decay of a metastable low-coverage phase (monolayer adsorption) in a square lattice-gas model of electrochemical metal deposition is investigated by kinetic Monte Carlo simulations. The phase-transformation dynamics are compared to the...

  • Atomic and electronic structures of LiTiO/LiTiO (001) interfaces by first-principles calculations. Tanaka, Shingo; Kitta, Mitsunori; Tamura, Tomoyuki; Maeda, Yasushi; Akita, Tomoki; Kohyama, Masanori // Journal of Materials Science;Jun2014, Vol. 49 Issue 11, p4032 

    We have performed density-functional theory calculations for LiTiO/LiTiO (LTO/Li-LTO) interfaces and made a detailed analysis of the local atomic and electronic structures. In the bulk regions of the supercell, the atomic and electronic structures are well reproduced to be similar to those of...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics