TITLE

Electrodeposition of lead dioxide on carbon substrates from a high internal phase emulsion (HIPE)

AUTHOR(S)
Blood, P.J.; Brown, I.J.; Sotiropoulos, S.
PUB. DATE
January 2004
SOURCE
Journal of Applied Electrochemistry;Jan2004, Vol. 34 Issue 1, p1
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
PbO2 coatings on carbon electrode substrates were produced by anodic electrodeposition from a stationary high internal phase emulsion (HIPE) with the bath components added in the water phase. The deposits have a distinct structure consisting of 10–50 μm high pyramidal aggregates, pitted with smaller pores. This is attributed to the growth of the deposits through the aqueous network of the HIPE emulsion that is, through the tortuous paths formed by its interconnected water cavities. The coatings thus produced are characterised by enhanced electrochemical activity towards the PbO2/PbSO4 transformation.
ACCESSION #
16781868

 

Related Articles

  • Effects of thiourea and urea on zinc—cobalt electrodeposition under continuous current. Mouanga, M.; Ricq, L.; Berçot, P. // Journal of Applied Electrochemistry;Feb2008, Vol. 38 Issue 2, p231 

    The effect of thiourea and urea on zinc-cobalt alloys obtained from chloride baths under continuous current deposition are described and discussed. The deposit morphology was analyzed using Scanning Electron Microscopy (SEM) and an X-Ray Diffraction (XRD) was used to determine the preferred...

  • Effect of surfactant BAS on MoS2 codeposition behaviour. Wang, L. M. // Journal of Applied Electrochemistry;Feb2008, Vol. 38 Issue 2, p245 

    Ni–MoS2 metal matrix composites were produced by electrodeposition in a Watts bath. The correlation of embedded particle ratio and operational parameters was studied. When surfactant BAS was adsorbed on the MoS2 particle surface, the conductivity of the MoS2 was significantly decreased....

  • Effect of alkyl chain length on the electrochemical perfluorination of n-alkane (C6—C10) carboxylic acid chlorides. Ilayaraja, N.; Manivel, A.; Velayutham, D.; Noel, M. // Journal of Applied Electrochemistry;Feb2008, Vol. 38 Issue 2, p175 

    Electrochemical perfluorination (ECPF) of n-hexanoyl, n-heptanoyl, n-octanoyl, n-nonanoyl and n-decanoyl chlorides was carried out under identical experimental conditions in liquid HF. The product distribution among perfluorinated carboxylic acids, perfluoro ethers, perfluoroalkanes, isomerised...

  • Influence of cobalt ions on the anodic oxidation of a lead alloy under conditions typical of copper electrowinning. Nguyen, T.; Guresin, N.; Nicol, M.; Atrens, A. // Journal of Applied Electrochemistry;Feb2008, Vol. 38 Issue 2, p215 

    The influence of cobalt ions in the solution on the anodic oxidation of a commercial Pb–Ca–Sn alloy under conditions typical of copper electrowinning was studied using cyclic voltammograms and potential decay transients. The cobalt ions changed the structure, morphology and...

  • Formation of nanoporous oxide at aluminum anodizing. Shcherbakov, A. I.; Skvortsova, I. B.; Zolotarevskii, V. I.; Chernova, G. P.; Mashchenko, V. E. // Protection of Metals & Physical Chemistry of Surfaces;Jan2009, Vol. 45 Issue 1, p67 

    The effect of electrochemical anodic oxidation on the formation of porous anodic oxide films (PAOF) on a high-grade aluminum (99.99%) in a sulfuric acid solution is studied. Anodizing modes are chosen such as to obtain PAOF with ordered nanostructure. It is shown that under an atomic force...

  • Comparison of the corrosion behaviour in 5% NaCl solution of Mg alloys NZ30K and AZ91D. Chang, J. W.; Peng, L. M.; Guo, X. W.; Atrens, A.; Fu, P. H.; Ding, W. J.; Wang, X. S. // Journal of Applied Electrochemistry;Feb2008, Vol. 38 Issue 2, p207 

    The corrosion behaviour of AZ91D and NZ30K (Mg–3Nd–0.2Zn–0.4Zr) alloys was investigated in 5% NaCl solution by immersion tests and electrochemical measurements. The immersion tests showed that the corrosion rate of NZ30K was about half that of AZ91D. The localized corrosion...

  • Hydrogen overvoltage at manganese in ammonium-bromide-perchloric solution. Kozin, L. F.; Mashkova, N. V.; Manilevich, F. D. // Protection of Metals & Physical Chemistry of Surfaces;Jan2009, Vol. 45 Issue 1, p25 

    Kinetic characteristics of electrochemical hydrogen evolution at manganese rotating disc electrode in ammonium-bromide-perchloric solution at 18, 40, and 60°C are determined (the overvoltage, Tafel slopes, exchange currents, and activation energy). The zero-charge potential is found....

  • Electrochemical properties of iron silicocarbide and cementite in acidic and neutral environments. Syugaev, A. V.; Lomaeva, S. F.; Maratkanova, A. N.; Surnin, D. V.; Reshetnikov, S. M. // Protection of Metals & Physical Chemistry of Surfaces;Jan2009, Vol. 45 Issue 1, p81 

    Voluminous specimens of individual Fe5SiC iron silicocarbide and Fe3C iron carbide phases were produced by mechanical alloying with subsequent pressing and considered as models of nonmetallic inclusions in carbon steels and siliceous cast irons. In an acidic sulfate solution, silicocarbide is...

  • A comparative study of the electrochemical behaviour of Algerian zinc and a zinc from a commercial sacrificial anode. Bounoughaz, M.; Salhi, E.; Benzine, K.; Ghali, E.; Dalard, F. // Journal of Materials Science;Mar2003, Vol. 38 Issue 6, p1139 

    Zinc is used in the oil industry as a sacrificial anode for protecting steel storage tanks from corrosion. The behaviour of a sample of zinc from the Algerian metallurgy industry (zinc A) and a commercially available zinc (zinc B) was compared in an electrolyte from storage tank drainage water....

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics