TITLE

All-epitaxial, lithographically defined, current- and mode-confined vertical-cavity surface-emitting laser based on selective interfacial fermi-level pinning

AUTHOR(S)
Ahn, J.; Lu, D.; Deppe, D. G.
PUB. DATE
January 2005
SOURCE
Applied Physics Letters;1/10/2005, Vol. 86 Issue 2, p021106
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
An approach is presented to fabricate a current- and mode-confined vertical-cavity surface-emitting laser that is all-epitaxial and lithographically defined. The device uses selective Fermi level pinning to self-align the electrical injection to a mode-confining intracavity phase-shifting mesa.
ACCESSION #
15644159

 

Related Articles

  • Mitigation of fast ions generated from laser-produced Sn plasma for extreme ultraviolet light source by H2 gas. Nakamura, Daisuke; Tamaru, Koji; Hashimoto, Yuki; Okada, Tatsuo; Tanaka, Hiroki; Takahashi, Akihiko // Journal of Applied Physics;Dec2007, Vol. 102 Issue 12, p123310 

    One of the serious problems in the laser-produced plasma for an extreme ultraviolet (EUV) light source used for the next generation lithography is the generation of fast ions that damage the EUV collector optics. In this study, the mitigation of fast ions from a laser-produced Sn plasma by a H2...

  • Laser-Produced Plasma Light Sources for EUV Lithography. Brandt, David C.; Fomenkov, Igor V.; La Fontaine, Bruno M.; Lercel, Michael J. // Solid State Technology;Jun2012, Vol. 55 Issue 5, p26 

    The article focuses on laser-produced plasma (LPP) light sources, as well as their application in extreme ultraviolet (EUV) lithography. It cites the three major subsystems of the source such as the drive laser, beam transport system (BTS), and source vessel. It also notes a test source...

  • Simple fabrication technique of distributed-feedback polymer laser by direct photonanoimprint lithography. Yamashita, K.; Arimatsu, M.; Takayama, M.; Oe, K.; Yanagi, H. // Applied Physics Letters;6/16/2008, Vol. 92 Issue 24, p243306 

    This paper describes a fabrication technique of polymeric distributed-feedback lasers using the photonanoimprint lithography. In devices with a grating structure, which was imprinted directly onto the active layer surface in vacuum, single-mode laser oscillations were easily obtained. The...

  • Universities win $17 million EUV grant. Kincaid, Kathy; Wallace, John // Laser Focus World;Dec2003, Vol. 39 Issue 12, p40 

    Reports that research universities in the U.S. have received a National Science Foundation (NSF) grant to develop laser-driven light sources for extreme-ultraviolet lithography. Research conducted at the NSF Engineering Research Center for Extreme Ultraviolet (EUV) Science and Technology;...

  • Ultracompact cladding-pumped 35-mm-short fiber laser with 4.7-W single-mode output power. Li, L.; Schülzgen, A.; Temyanko, V. L.; Morrell, M. M.; Sabet, S.; Li, H.; Moloney, J. V.; Peyghambarian, N. // Applied Physics Letters;4/17/2006, Vol. 88 Issue 16, p161106 

    We report on ultracompact cladding-pumped fiber lasers, fabricated from single-mode phosphate glass microstructured optical fibers, with several watts of cw output at 1.5 μm. A maximum cw output power of 4.7 W has been achieved from a fiber laser that is only 35 mm in length, corresponding to...

  • Numerical solution and experiment of a self-Q-switched 946 nm Cr,Nd:YAG laser. Li, Q.; Feng, B.; Zhang, D.; Du, S.; Shi, Y.; Zhang, Z.; Zhang, S. // Applied Physics B: Lasers & Optics;Nov2008, Vol. 93 Issue 2/3, p421 

    A LD-pumped self-Q-switched 946 nm laser by using a co-doped Cr,Nd:YAG crystal as a gain medium as well as a saturable absorber is studied. The 946 nm self-Q-switched rate equations of co-doped crystal are solved numerically by Runge–Kutta method directly. The important parameters of...

  • Improvement of the atmospheric discharge laser-triggered ability using multiple pulses from a kilohertz KrF laser. Yamaura, Michiteru // Journal of Applied Physics;8/15/2005, Vol. 98 Issue 4, p043101 

    The potential ability of lasers to control lightning can be improved by using a train of pulses with submillisecond separations. Laser-triggered experiments in a small-scale (10-mm gap) atmospheric discharge facility show that the triggering is dramatically enhanced when a five-pulse train of...

  • Progress toward “optical beam induced noise” measurement set-up. Routoure, Jean-Marc; Méchin, Laurence; Flament, Stéphane // AIP Conference Proceedings;2005, Vol. 780 Issue 1, p681 

    The paper presents an experimental set-up dedicated to noise measurements of samples under laser spot illumination. The laser is scanned on the surface which locally heats. The noise level is recorded at each positions. The final purpose of the system is to detect spatial inhomogeneities in the...

  • Very High Temperature Operation of ∼ 5.75 μm Quantum Cascade Lasers. Friedrich, A.; Scarpa, G.; Boehm, G.; Amann, M.-C. // AIP Conference Proceedings;2005, Vol. 772 Issue 1, p1567 

    We have fabricated GaInAs/AlInAs strain-compensated quantum cascade lasers with InP and GaInAs cladding layers using solid-source molecular-beam epitaxy (MBE). Low threshold current densities and high temperature operation of uncoated devices, with a record value of 490 K, have been achieved in...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics