TITLE

TSSOP-20 4-channel 24-bit DAC provides 240 samples/s

PUB. DATE
December 2004
SOURCE
Portable Design;Dec2004, Vol. 10 Issue 12, p35
SOURCE TYPE
Periodical
DOC. TYPE
Article
ABSTRACT
The article presents information on the ADS 1224 four-channel 24-bit delta-sigma ADC. It provides a 240-sample/s data rate and is designed for high-resolution measurement applications where space and power consumption are critical, such as portable instrumentation, portable medical equipment, industrial process control, remote sensors and smart transmitters. The converter includes a four-channel differential input multiplexer, which accepts rail-to-rail inputs and features a temperature sensor for ambient temperature measurement. The ADC quickly shuts down (standby mode) while idle between measurements to dramatically reduce overall power consumption.
ACCESSION #
15445498

 

Related Articles

  • ENHANCED DYNAMIC PERFORMANCE OF MATRIX CONVERTER CAGE DRIVE WITH NEURO-FUZZY APPROACH. Joshi, R. R.; Gupta, R. A.; Wadhwani, A. K. // Journal of Theoretical & Applied Information Technology;2007, Vol. 3 Issue 2, p19 

    This paper proposes a new control algorithm for a matrix converter (MC) induction motor drive system. First, a new switching strategy, which applies a back-propagation neural network to adjust a pseudo dc bus voltage, is proposed to reduce the current harmonics of the induction motor. Next, a...

  • 48V AC-DC with isolated output.  // Electronics Weekly;11/24/2004, Issue 2172, p52 

    This article reports that a safety isolated 48V output and on-board active power factor correction are featured in a 600 W AC-DC converter from C&D Technologies Inc. Operating across an input voltage range of 85-264Vac, the PF600-1 can deliver its full-rated 600W of power with input voltages...

  • ENERGY-HARVESTING ICS SUPPLY ALL SYSTEM VOLTAGES DIRECTLY FROM TRANSDUCERS. Tuite, Don // Electronic Design;2/11/2010, Vol. 58 Issue 2, p24 

    The article evaluates the energy-harvesting electronic chips LTC3180 step-up converter/power and the LTC3855-1 power supply from Linear Technologies Corp.

  • Isolated power converter for low voltage.  // Electronics Weekly;4/27/2005, Issue 2191, p44 

    This article presents information on C&D Technologies which has a range of single-output, isolated converters with output currents of 6A and output voltages down to 1.8V. Available in three industry standard pin patterns, the NPX2O series offers a choice of two input voltage ranges nominal 24V...

  • DC-DC Controller.  // Power Electronics Technology;May2006, Vol. 32 Issue 5, p56 

    The article presents information about LT3844 dc-dc controller from Linear Technology Corp. It has adjustable switching frequency and can be synchronized to an external clock. It can also be used in stepdown, stepup, inverting and SEPIC converters. The device is highly efficient at light loads...

  • Stepdown Converter.  // Power Electronics Technology;May2006, Vol. 32 Issue 5, p60 

    This article presents information on the AATI 121 stepdown converter from Sunnyvale, California-based Advanced Analogic Technologies Inc. The converter gives current output of 250-mA at up to 96% efficiency. The converter can be operated between the input range of 2.7-V to 5.5-V with an output...

  • Distributed Power Needs Distributed Cooling. Crews, Ron // Power Electronics Technology;Nov2002, Vol. 28 Issue 11, p14 

    Reports that increased performance demands and reduced space are making thermal management a major design challenge for direct current-direct current converters employed in distributed power architecture systems. Key issues of interest; Analysis of pertinent topics and relevant issues;...

  • Consider SEPIC Topology for New Designs. Rahban, Thierry // Power Electronics Technology;Nov2002, Vol. 28 Issue 11, p18 

    Reports that classic single-ended primary inductive converter topology has advantages for lithium-based converters and power factor correction circuits because of its input voltage range can overlap the output voltage. Key issues of interest; Analysis of pertinent topics and relevant issues;...

  • ABB Positions Powerful Offshore Wind Connector in North Sea.  // Transmission & Distribution World Exclusive Insight;9/ 3/2013, p2 

    The article reports that ABB installed the highest-voltage offshore converter station in the North Sea with alternating current electricity generated from the wind farms to be converted on the platform into high-voltage direct current (HVDC) for transmission to the mainland.

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics