TITLE

Visualization of second-order nonlinear layer in thermally poled fused silica glass

AUTHOR(S)
An, Honglin; Fleming, Simon; Cox, Guy
PUB. DATE
December 2004
SOURCE
Applied Physics Letters;12/13/2004, Vol. 85 Issue 24, p5819
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Second-harmonic microscopy has been applied to characterize the second-order nonlinear layer in fused silica plates thermally poled at 280 °C and 3.5 kV for different time intervals. The nonlinear layer is found only under the anode surface and to be ∼5 μm deep under the anode for a poling time of 30 min. Progression of this layer into the bulk glass with poling time is also characterized.
ACCESSION #
15331900

 

Related Articles

  • Formation and thermal stability of CoSi2 on polycrystalline Si. Vaidya, S.; Murarka, S. P.; Sheng, T. T. // Journal of Applied Physics;7/15/1985, Vol. 58 Issue 2, p971 

    Explores the temperature stability of CoSi[sub2]/polycrystalline-silicon/silicon dioxide structures by techniques of Rutherford backscattering, scanning and transmission electron microscopy. Formation of CoSi[sub2] on polycrystalline silicon; Dependence of the stability of co-sputtered films on...

  • High-aperture optical waveguides based on fluorine-doped silica glass. Guryanov, A.; Salganskii, M.; Khopin, V.; Kosolapov, A.; Semenov, S. // Inorganic Materials;Jul2009, Vol. 45 Issue 7, p823 

    The dependence of fluorine incorporation into silica glass on conditions of the optical waveguide blank manufacture using the method of modified chemical vapor deposition (MCVD) is studied. The degree of fluorine incorporation at constant consumption of a fluoridizer (SiF4) is shown to increase...

  • A microfluidic mixing system for single-molecule measurements. Pfeil, Shawn H.; Wickersham, Charles E.; Hoffmann, Armin; Lipman, Everett A. // Review of Scientific Instruments;May2009, Vol. 80 Issue 5, p055105 

    This article describes the design and fabrication of a microfluidic mixing system optimized for ultrasensitive optical measurements. Channels are replica-molded in polydimethylsiloxane elastomer and sealed with fused-silica coverglass. The resulting devices have broad chemical compatibility and...

  • Preparation of Palladium-Supported Periodic Mesoporous Organosilicas and their Use as Catalysts in the Suzuki Cross-Coupling Reaction. Corral, Jorge A.; López, María I.; Esquivel, Dolores; Mora, Manuel; Jiménez-Sanchidrián, César; Romero-Salguero, Francisco J. // Materials (1996-1944);Apr2013, Vol. 6 Issue 4, p1554 

    Three periodic mesoporous materials, i.e., two organosilicas with either ethylene or phenylene bridges and one silica, have been used as supports for Pd nanoparticles. All Pd-supported samples (1.0 wt%) were prepared by the incipient wetness method and subsequently reduced in an H2 stream at 200...

  • SiO2 buried layer formation by subcritical dose oxygen ion implantation. Stoemenos, J.; Margail, J.; Jaussaud, C.; Dupuy, M.; Bruel, M. // Applied Physics Letters;5/26/1986, Vol. 48 Issue 21, p1470 

    The structure of the silicon dioxide buried layer formed by oxygen ion implantation at a subcritical dose i.e., 1.3×1018 ion cm-2 at 200 keV is studied. The beneficial effect of a high annealing temperature at 1300 °C for 6 h is discussed. A method for estimation of the total amount of...

  • Near-field microwave microscope measurements to characterize bulk material properties. Imtiaz, Atif; Baldwin, Thomas; Nembach, Hans T.; Wallis, Thomas M.; Kabos, Pavel // Applied Physics Letters;6/11/2007, Vol. 90 Issue 24, p243105 

    The authors discuss near-field scanning microwave microscope measurements of the complex permittivity for bulk dielectric (fused silica), semiconductor (silicon), and metal (copper). The authors use these measurements to test existing quasistatic theoretical approach to deembed the bulk material...

  • Fabrication and annihilation of nanovoids in Cu nanoclusters by ion implantation into silica and subsequent annealing. Ren, F.; Jiang, C. Z.; Liu, C.; Wang, J. B. // Applied Physics Letters;5/1/2006, Vol. 88 Issue 18, p183114 

    Cu ions were implanted at 180 keV into silica with doses ranging from 5×1016 to 2×1017 ions/cm2. Cross-sectional transmission electron microscopy and high-resolution transmission electron microscopy images showed that Cu nanoclusters containing nanovoids have been formed for doses higher...

  • Quantitative characterization of agglomerates and aggregates of pyrogenic and precipitated amorphous silica nanomaterials by transmission electron microscopy. Pieter-Jan De Temmerman, Pieter-Jan De Temmerman; Van Doren, Elke; Verleysen, Eveline; Van der Stede, Yves; Abi Daoud Francisco, Michel; Mast, Jan // Journal of Nanobiotechnology;2012, Vol. 10 Issue 1, p24 

    Background: The interaction of a nanomaterial (NM) with a biological system depends not only on the size of its primary particles but also on the size, shape and surface topology of its aggregates and agglomerates. A method based on transmission electron microscopy (TEM), to visualize the NM and...

  • Modification of the surface of nanodisperse amorphous silica prepared by fluoride technology. Demyanova, L.; Tressaud, A. // Protection of Metals & Physical Chemistry of Surfaces;Mar2012, Vol. 48 Issue 2, p211 

    The physicochemical properties of amorphous silica prepared by the fluoride technology are studied; the surface of silica is modified by direct fluorination with F-gas or c-C4F8 radio-frequency plasma. The modification of the surface physical chemical properties after fluorination are compared...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics