TITLE

ENGINEERING A BETTER BULB

AUTHOR(S)
Pacella, Rena Marie
PUB. DATE
January 2005
SOURCE
Popular Science;Jan2005, Vol. 266 Issue 1, p34
SOURCE TYPE
Periodical
DOC. TYPE
Article
ABSTRACT
Discusses the possibility of using light-emitting diodes (LED) made from zinc oxide instead of tungsten filament light bulbs. Advantages of LED made from zinc oxide as compared to tungsten filaments; Implications of switching to LED systems.
ACCESSION #
15307883

 

Related Articles

  • Simulation of hybrid ZnO/AlGaN single-heterostructure light-emitting diode. Bulashevich, Kirill A.; Evstratov, Igor Yu.; Nabokov, Vladislav N.; Karpov, Sergey Yu. // Applied Physics Letters;12/12/2005, Vol. 87 Issue 24, p243502 

    Using simulations, we have examined specific features of a hybrid n-ZnO/p-AlGaN light-emitting diode (LED) operation, originated from a type-II band alignment and a negative polarization charge at the ZnO/AlGaN interface. These factors are found to improve the carrier confinement near the...

  • All done with mirrors. Fisher, Richard // Engineer (00137758);8/6/2004, Vol. 293 Issue 7657, p13 

    Reports on the development of an enhanced light-emitting device. Death knell for the incandescent light bulb.

  • Picture This.  // EC&M Electrical Construction & Maintenance;Aug2005, Vol. 104 Issue 8, p10 

    Presents a photograph of S14L LED cluster lamps, which hide solid-state technology under incandescent dressings. Lamps from LEDtronics which can go anywhere standard light bulbs can and even a few places they cannot; Amount of light produced by each bulb; Possible use in signage or daylighting.

  • Getting the Green Light. Marin, Matthew // Kitchen & Bath Business;Oct2008, Vol. 55 Issue 10, p28 

    The article focuses on the energy-efficient lighting sources for the kitchen. According to the U.S. Environmental Protection Agency, compact fluorescent lamps use about 75 percent less energy than standard incandescent sources and last up to 10 times longer. Light emitting diodes (LED), on the...

  • The SPLEDs have landed.  // Vending International;Jan2005, Vol. 39 Issue 1, p10 

    Reports on the introduction of a range of SPLED or SPlined light emitting diode by Forge Europa. Usefulness of the product in a huge range of illumination applications including backlighting and filament bulbs replacement; Features of the product; Availability of electrical configurations upon...

  • OPTIMIZING OPERATING LIFE FOR LED-BASED LIGHTBULBS. BROWN, SCOTT // EDN;Dec2012, Vol. 57 Issue 18, p29 

    The article focuses on the driver implementation that would optimize the operating life of light-emitting diode (LED)-based lightbulbs. The advantages of LED bulbs over incandescent bulbs are presented along with the areas of concern concerning compatibility with legacy dimmer technology. The...

  • Top 3 Trends in Colored LED Applications.  // Buildings;May2014, Vol. 108 Issue 5, p14 

    The article reports on top three trends in the use of colored light-emitting diode (LED) as of May 2014, including upgrading of efficiency, the ability to change lighting as required, and the shift to systems thinking rather than by individual components.

  • True Colors. Daniello, Vincent // Yachting;Jan2011, Vol. 209 Issue 1, p74 

    The article focuses on the developments in light emitting diodes (LEDs), will last 50,00 hours, that make several yachtsmen rethink the lighting of their vessels.

  • Untitled. Bush, Steve // Electronics Weekly;11/9/2011, Issue 2487, p8 

    The article focuses on a study conducted by researcher Zhong Lin Wang and his team at Georgia Tech university in which the efficiency of ultra-violet (390nm) thin-film GaN light-emitting diodes (LEDs) by adding a zinc oxide microwire to the junction. Researcher Zhong says that due to the...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics