TITLE

Magnetic anisotropy of Fe3Pt alloy thin films

AUTHOR(S)
Nahid, M.A.I.; Suzuki, Takao
PUB. DATE
November 2004
SOURCE
Applied Physics Letters;11/1/2004, Vol. 85 Issue 18, p4100
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
The magnetic anisotropy constants of Fe3Pt alloy thin films grown onto MgO(100) and MgO(111) substrates by electron-beam evaporation are investigated in conjunction with structure. It is observed that the orientation of the Fe3Pt films depends on the substrate. Both oriented samples exhibit very large in-plane magnetic anisotropy. The magnetic anisotropy constants K1 and K2 are found to strongly depend on the deposition temperature (TS). The maximum values of K1 and K2 obtained are about -4×106 and 2×107 erg/cc, respectively. A close relationship is observed between the magnetic anisotropy constants and structural parameter.
ACCESSION #
14945488

 

Related Articles

  • In situ growth of c-axis-oriented Ca3Co4O9 thin films on Si (100). Hu, Y. F.; Si, W. D.; Sutter, E.; Li, Qiang // Applied Physics Letters;2/21/2005, Vol. 86 Issue 8, p082103 

    High-quality c-axis-oriented Ca3Co4O9 thin films have been grown directly on Si (100) wafers by pulsed-laser deposition without prechemical treatment of the substrate surface. Cross-sectional transmission electron microscopy shows good crystallinity of the Ca3Co4O9 films. The Seebeck coefficient...

  • Magnetoelectric CoFe2O4–Pb(Zr,Ti)O3 composite thin films derived by a sol-gel process. Wan, J. G.; Wang, X. W.; Wu, Y. J.; Zeng, M.; Wang, Y.; Jiang, H.; Zhou, W. Q.; Wang, G. H.; Liu, J.-M. // Applied Physics Letters;3/21/2005, Vol. 86 Issue 12, p122501 

    Magnetoelectric (ME) CoFe2O4–Pb(Zr,Ti)O3 composite thin films have been prepared by a sol-gel process and spin-coating technique. X-ray diffraction and scanning electron microscopy reveal that there exists local aggregation or phase separation of the CoFe2O4 and Pb(Zr,Ti)O3 phases in the...

  • High electron mobility In2O3(001) and (111) thin films with nondegenerate electron concentration. Bierwagen, Oliver; Speck, James S. // Applied Physics Letters;8/16/2010, Vol. 97 Issue 7, p072103 

    Temperature dependent Hall measurements were applied to demonstrate, semiconducting n-type high-quality In2O3(001) and (111) thin films with nondegenerate unintentionally doped (UID) electron concentrations on the order of 1017 cm-3 at room temperature, which is below those of bulk single...

  • Deposition of epitaxial Ti2AlC thin films by pulsed cathodic arc. Rosén, J.; Ryves, L.; Persson, P. O. Å.; Bilek, M. M. M. // Journal of Applied Physics;3/1/2007, Vol. 101 Issue 5, p056101 

    A multicathode high current pulsed cathodic arc has been used to deposit Ti2AlC thin films belonging to the group of nanolaminate ternary compounds of composition Mn+1AXn. The required stoichiometry was achieved by means of alternating plasma pulses from three independent cathodes. We present...

  • WC/a-C nanocomposite thin films: Optical and electrical properties. Abad, M. D.; Sánchez-López, J. C.; Cusnir, N.; Sanjines, R. // Journal of Applied Physics;Feb2009, Vol. 105 Issue 3, pN.PAG 

    WC/amorphous carbon (a-C) thin films were deposited by dual magnetron sputtering from individual WC and graphite targets. The influence of film composition and microstructure on the optical and electrical properties was investigated. As evidenced by x-ray photoelectron spectroscopy and grazing...

  • Growth and characteristics of low dislocation density GaN grown on Si(111) from a single process. Chen, X.; Uesugi, T. // Applied Physics Letters;1/16/2006, Vol. 88 Issue 3, p031916 

    From one uninterrupted growth process, GaN films were deposited on maskless stripe-patterned Si(111) substrates using the facet-initiated growth technique. The epilayer with a flat surface has a thickness of ∼1.3 μm. The influence of stress on the behavior of dislocations in the crystal...

  • Formation of nanoporous noble metal thin films by electrochemical dealloying of PtxSi1-x. Thorp, J. C.; Sieradzki, K.; Lei Tang; Crozier, P. A.; Misra, Amit; Nastasi, Michael; Mitlin, David; Picraux, S. T. // Applied Physics Letters;1/16/2006, Vol. 88 Issue 3, p033110 

    We demonstrate the synthesis of nanoporous Pt thin films on Si by electrochemical dealloying. Amorphous PtxSi1-x films (∼100–250 nm thick) are formed by electron beam codeposition and dealloyed in aqueous HF solutions at an electrochemical potential sufficient to selectively remove...

  • Synthesis and ferroelectric properties of epitaxial BiFeO3 thin films grown by sputtering. Das, R. R.; Kim, D. M.; Baek, S. H.; Eom, C. B.; Zavaliche, F.; Yang, S. Y.; Ramesh, R.; Chen, Y. B.; Pan, X. Q.; Ke, X.; Rzchowski, M. S.; Streiffer, S. K. // Applied Physics Letters;6/12/2006, Vol. 88 Issue 24, p242904 

    We have grown epitaxial BiFeO3 thin films with smooth surfaces on (001), (101), and (111) SrTiO3 substrates using sputtering. Four-circle x-ray diffraction and cross-sectional transmission electron microscopy show that the BiFeO3 thin films have rhombohedral symmetry although small monoclinic...

  • THE DYNAMICS OF RELIEF OF THIN FILM SURFACE AND DEPENDENCE ON TECHNOLOGICAL PARAMETERS IN EARLY GROWTH STAGE. Čerapaitė-Trušinskienė, R.; Galdikas, A. // International Conference: Radiation Interaction with Material & ;2006, p291 

    For the deposition of thin films it is important to know under what parameters' values film whit desirable morphology and relief will be obtained. One of the parameter which can influencing the relief of thin film is substrate temperature. As the relief of thin film is determined by the first...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics