TITLE

Micromechanics of fracture in a ceramic/metal composite studied by in situ fluorescence spectroscopy II: fracture mechanics analysis

AUTHOR(S)
Pezzotti, G.; M�ller, W.H.
PUB. DATE
July 2004
SOURCE
Continuum Mechanics & Thermodynamics;Jul2004, Vol. 16 Issue 5, p471
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
Fluorescence microprobe spectroscopy was used in [1] to determine in situ microstress fields that develop during fracture in a model ceramic/metal composite. In particular, experimental and theoretical procedures were described in order to relate the experimental peak-shift to the various stress components and combinations thereof. Based on suitable micromechanical concepts, these stress maps are now used to predict quantities related to the fracture mechanics, such as (critical) stress intensity factors, R-curves, and crack-opening displacements. All predictions are compared with direct measurements of these quantities to demonstrate the feasibility and soundness of the micromechanics approach.
ACCESSION #
13719608

 

Related Articles

  • Failure Modes and Fracture Origins of Porcelain Veneers on Bilayer Dental Crowns. Yihong Liu; Guanghua Liu; Yong Wang; Shen, James Zhijian; Hailan Feng // International Journal of Prosthodontics;2014, Vol. 27 Issue 2, p147 

    The aims of this study were to determine the fracture origins and crack paths in the porcelain of clinically failed bilayer ceramic restorations and to reveal the correlation between the porcelain failures and material properties. Three clinically failed crowns of each material (bilayer zirconia...

  • Influence of initial stresses on fracture of composite materials containing interacting cracks. Bogdanov, V. L. // Journal of Mathematical Sciences;Mar2010, Vol. 165 Issue 3, p371 

    Considered in this study are the axially-symmetric problems of fracture of composite materials with interacting cracks, which are subjected to initial (residual) stresses acting along the cracks planes. An analytical approach within the framework of three-dimensional linearized mechanics of...

  • Fracture Behavior Simulation Using Multi-Scale Analysis Scheme under Various Thermal Conditions. Juwhan Kim; Yun Mook Lim; Kunwhi Kim // AIP Conference Proceedings;2/15/2008, Vol. 973 Issue 1, p100 

    A series of fracture simulations are performed and presented. A two dimensional configuration with a notch is assembled via the popular Lennard-Jones (LJ) potential, and the configuration is subjected to displacement controlled tension tests. Five sets of analyses are performed at different...

  • FEA simulates and models strength of Z-pinned composites.  // Advanced Materials & Processes;Nov2007, Vol. 165 Issue 11, p18 

    The article reports on a method of simulating crack growth in Z-pinned composite structures developed by ATA Engineering. The need to predict the failure mode and load-carrying capabilities of composite structures and the analytical complexity involved with Z-pinning are discussed. The concepts...

  • Deformation and short-term damage of physically nonlinear stochastic composites. Khoroshun, L. P.; Shikula, E. N. // International Applied Mechanics;Jun2009, Vol. 45 Issue 6, p613 

    The studies on the deformation and short-term damage of physically nonlinear homogeneous and composite materials are systemized. A single microdamage is modeled by an empty quasispherical pore in place of a microvolume damaged in accordance with the Huber�von Mises failure criterion. The...

  • Internal stress induced texture in Ni-Mn-Ga based glass-covered microwires. Rodionova, V.; Ilyn, M.; Granovsky, A.; Perov, N.; Zhukova, V.; Abrosimova, G.; Aronin, A.; Kiselev, A.; Zhukov, A. // Journal of Applied Physics;Sep2013, Vol. 114 Issue 12, p123914 

    We have studied magnetic and structural properties of the composite microwires consisted of the metallic core and the outer glass shell. Nominal chemical composition of the core was Ni49.5Mn25.4Ga25.1, its diameter was 13.2 μm, and the total diameter of the glass-covered microwires was 26.4...

  • Wet erosion damage of Cr[sub3[C[sub2]/Al[sub2]O[sub3] composite. Jeng, Ching-An; Huang, Jow-Lay // Journal of Materials Research;May2003, Vol. 18 Issue 5, p1162 

    Presents information on a study that investigated the role of interfacial microcracking of injection-molded Cr[sub3]C[sub2]/Al[sub2]O[sub3] composite on the erosion mechanism under an impingement erosion test rig. Methodology of the study; Results and discussion on the study.

  • Detection of microfracture processes in composite laminates by thermo-acoustic emission. Nak-Sam Choi; Young-Bok Kim; Tae-Won Kim; Rhee, Kyong Y. // Journal of Materials Science;Mar2003, Vol. 38 Issue 5, p1013 

    The damage process in composite laminates subjected to cryogenic cooling was monitored employing a thermo-acoustic emission (AE) technique. The thermo-AE signals processed with a short-time Fourier transform could be classified into three different types which were correlated with individual...

  • Influence of Initial Stresses on Stress Intensity Factors at Crack Tips in a Composite Strip. Akbarov, S. D.; Yahnioglu, N.; Turan, A. // Mechanics of Composite Materials;Jul/Aug2004, Vol. 40 Issue 4, p299 

    The influence of initial tension or compression along cracks on the stress intensity factor (SIF) at crack tips under the action of additional normal forces on crack edges is studied for infinite bodies. A strip made of a composite material is considered. The strip ends are simply supported, and...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics