TITLE

Line-modulation-based flux-weakening control for permanent-magnet synchronous machines

AUTHOR(S)
Wei Wang; Jinghao Zhang; Ming Cheng
PUB. DATE
April 2018
SOURCE
IET Power Electronics;2018, Vol. 11 Issue 5, p930
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
A line-modulation-based flux-weakening control is proposed for surface-mounted permanent-magnet synchronous machines. To evaluate the average dc bus voltage utilisation, the maximum line-modulation-ratio, which cannot be >1, is defined. If the maximum line-modulation-ratio is equal to 1, the voltage capacity of voltage-source-inverter is fully utilised, which means the dc bus voltage utilisation has been maximised. Without special declarations, the overmodulation scheme is not utilised in this study. The line modulation is employed in the proposed flux-weakening control, in which the average dc bus voltage utilisation can be maximised by regulating the maximum line-modulation-ratio to 1. Compared with the conventional fluxweakening control, the proposed one is simpler and its copper loss can be reduced. The reason is that the proposed fluxweakening control employs the line modulation while the conventional flux-weakening control usually adopts the space vector pulse width modulation. The effectiveness of the proposed flux-weakening control is verified by experimental results.
ACCESSION #
129176583

 

Related Articles

  • Coordinated Control of Dual PWM Converter for Elevator Drives. Han Shuang; Zheng Jiong; Luo Zhiqun; Wan Jianru // Elevator World;Jul2012, Vol. 60 Issue 7, p50 

    The article focuses on the coordinated control of dual pulse-width modulation (PWM) converters integrating elevator drives with energy feedback. It states that the energy difference between the rectifier and inverter per unit time can decrease if the power flow of the rectifier equals the...

  • Performance and Measurement of Current Control Schemes in Grid connected Inverters. Yuvaraja, T.; Gopinath, M. // Australian Journal of Basic & Applied Sciences;Jun2014, Vol. 8 Issue 9, p163 

    Background: Applications such as digital based control in grid connected output currents are measured accurately. So obtaining the accuracy I must in the design consideration. The proposed work analyze the single and three phase measurement of grid connected inverter and the current control...

  • An IFOC-DSVPWM Based DC-Link Voltage Compensation of Z-Source Inverter Fed Induction Motor Drive for EVs. Akkarapaka, Ananda Kumar; Singh, Dheerendra // Advances in Power Electronics;8/13/2015, Vol. 2015, p1 

    The drop in DC-link voltage of adjustable speed drives (ASD) occurs mainly due to the increase in output power demands. This may lead to inefficient operation and eventually the tripping of the drive. This paper presents a Double Space Vector Pulse Width Modulation (DSVPWM) technique for...

  • The Control Technology of the Z-source Three-phase Four-leg Inverter based on Computer Simulation. Ming Su; Xueyan Ma; Yan Sun // Advanced Materials Research;2014, Vol. 981, p688 

    Z-source inverter can boost the voltage of the DC-side, allow the two switches of the same leg conducting at the same time and it has some other advantages. The zero-sequence current flows through the fourth leg of the three-phase four-leg inverter so the three-phase four-leg inverter can work...

  • Zero-voltage-switching DC/AC inverter. Wang, C.-M. // IET Electric Power Applications;May2007, Vol. 1 Issue 3, p387 

    A novel zero-voltage-switching (ZVS) DC/AC inverter is proposed. The proposed inverter can not only provide output voltage that is higher or lower than DC input voltage but can also use the pulse-width modulation (PWM) control technique. Furthermore, in the proposed inverter, besides operating...

  • Single-phase multilevel inverter topologies with self-voltage balancing capabilities. Gautam, Shivam Prakash; Kumar, Lalit; Gupta, Shubhrata // IET Power Electronics;2018, Vol. 11 Issue 5, p844 

    In this study, two new structures of single-phase hybrid multilevel inverter are proposed for both symmetrical and asymmetrical configurations that can be employed in drives and control of electrical machines and connection of renewable energy sources. The proposed configuration uses a less...

  • Dynamic voltage restorer based on multilevel inverter with adjustable dc-link voltage. Babaei, Ebrahim; Kangarlu, Mohammad Farhadi; Sabahi, Mehran // IET Power Electronics;Mar2014, Vol. 7 Issue 3, p576 

    Dynamic voltage restorer (DVR) is a power electronic converter-based custom power device used to compensate for voltage variations. The inverter used in the DVR structure can have different topologies. Multilevel inverters are a good candidate to be used in the DVR structure especially in higher...

  • The X-connected inverter: a topology with higher fundamental and reduced low-order harmonic voltages. Maiti, Dipten; Biswas, Sujit K. // IET Power Electronics;Nov2013, Vol. 6 Issue 9, p1851 

    A new inverter topology is presented in the paper, which produces a reduced low-order harmonic voltage waveform because of a natural harmonic cancellation process. Two switches of each limb operate at low switching frequency, whereas the other two switches of the same limb operate at higher...

  • Phase-Shifted Carrier Pulse Width Modulation Based on Particle Swarm Optimization for Cascaded H-bridge Multilevel Inverters with Unequal DC Voltages. Xin-Jian Cai; Zhen-Xing Wu; Quan-Feng Li; Shu-Xiu Wang // Energies (19961073);Sep2015, Vol. 8 Issue 9, p9670 

    High-voltage cascaded H-bridge multilevel (CHBML) inverters usually include many isolated dc voltage sources. Some dc source faults result in a drop in the dc voltage, thereby leading to unequal cell dc voltages. On the other hand, the differences in cell dc source parameters result in unequal...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics