TITLE

Dense uniform arrays of site-controlled quantum dots grown in inverted pyramids

AUTHOR(S)
Watanabe, S.; Pelucchi, E.; Dwir, B.; Baier, M. H.; Leifer, K.; Kapon, E.
PUB. DATE
April 2004
SOURCE
Applied Physics Letters;4/12/2004, Vol. 84 Issue 15, p2907
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
We report on the growth and optical properties of homogeneous, dense arrays of site-controlled, single GaAs/AlGaAs quantum dot (QD) heterostructures with periodicities as small as 300 nm. The samples were grown by organometallic chemical vapor deposition on (111)B GaAs substrates containing dense inverted pyramid recess patterns prepared by electron beam lithography and wet chemical etching. Low-temperature microphotoluminescence spectra of the samples show distinct luminescence from the QDs with 1–3 meV linewidth. Low-temperature cathodoluminescence spectrally resolved images reveal uniform emission energy within an ensemble of 900 QDs. © 2004 American Institute of Physics.
ACCESSION #
12754096

 

Related Articles

  • Electrical activity of intragrain defects in polycrystalline silicon layers obtained by aluminum-induced crystallization and epitaxy. Van Gestel, D.; Romero, M. J.; Gordon, I.; Carnel, L.; D’Haen, J.; Beaucarne, G.; Al-Jassim, M.; Poortmans, J. // Applied Physics Letters;2/26/2007, Vol. 90 Issue 9, p092103 

    Defect etching revealed a very large density (∼109 cm-2) of intragrain defects in polycrystalline silicon (pc-Si) layers obtained through aluminum-induced crystallization of amorphous Si and epitaxy. Electron-beam-induced current measurements showed a strong recombination activity at these...

  • Single-hole transistor in p-type GaAs/AlGaAs heterostructures. Grbic, Boris; Leturcq, Renaud; Ensslin, Klaus; Reuter, Dirk; Wieck, Andreas D. // Applied Physics Letters;12/5/2005, Vol. 87 Issue 23, p232108 

    A single-hole transistor is patterned in a p-type, C-doped GaAs/AlGaAs heterostructure by scanning probe oxidation lithography. Clear Coulomb blockade resonances have been observed at Thole=300 mK. A charging energy of ∼1.5 meV is extracted from Coulomb diamond measurements, in agreement...

  • Negative differential conductance in planar one-dimensional/zero-dimensional/one-dimensional GaAs/AlGaAs structures. Worschech, L.; Reitzenstein, S.; Forchel, A. // Applied Physics Letters;11/27/2000, Vol. 77 Issue 22 

    By using high-resolution electron beam lithography and wet etching, we have fabricated semiconducting islands between quantum wires from GaAs/AlGaAs modulation-doped heterostructures. The zero-dimensional islands were realized by displacing a 180 nm section at the center of a 1 μm long and...

  • Fabrication of low loss two-dimensional InP photonic crystals by inductively coupled plasma etching. Pommerreau, F.; Legouézigou, L.; Hubert, S.; Sainson, S.; Chandouineau, J.-P.; Fabre, S.; Duan, G.-H.; Lombardet, B.; Ferrini, R.; Houdré, R. // Journal of Applied Physics;3/1/2004, Vol. 95 Issue 5, p2242 

    Low-loss bidimensional photonic crystals have been fabricated by using an optimized process, consisting of electron beam lithography of a poly(methyl methacrylate) resist, reactive ion etching of an intermediate dielectric layer, and inductively coupled plasma etching of InP-based...

  • Strain-induced low dimensional confinement structures. Sekkal, Nadir; Velasco, V. R. // Applied Physics Letters;11/17/2008, Vol. 93 Issue 20, p201104 

    We propose here confinement structures similar to heterostructures and superlattices. The present structures can be obtained by applying strain to a single material in a periodic or aperiodic way. The conversion of an indirect gap into an optical active direct or quasidirect gap problem has also...

  • Fabrication of high frequency nanometer scale mechanical resonators from bulk Si crystals. Cleland, A. N.; Roukes, M. L. // Applied Physics Letters;10/28/1996, Vol. 69 Issue 18, p2653 

    We report on a method to fabricate nanometer scale mechanical structures from bulk, single-crystal Si substrates. A technique developed previously required more complex fabrication methods and an undercut step using wet chemical processing. Our method does not require low pressure chemical vapor...

  • Conformal contact and pattern stability of stamps used for soft lithography. Bietsch[a], Alexander; Michel, Bruno // Journal of Applied Physics;10/1/2000, Vol. 88 Issue 7, p4310 

    Proposes guidelines for matching the mechanical properties of stamps to the requirements of their use for soft lithography. Master and stamp fabrication; Conformal contact; Sinusoidal roughness; Sphere-cap model; Local deformation of patterns; Replication accuracy of features.

  • Energy minimization mechanisms of semi-coherent interfaces. Shuai Shao; Wang, J.; Misra, Amit // Journal of Applied Physics;2014, Vol. 116 Issue 2, p023508-1 

    In this article, we discussed energy minimization mechanisms of semi-coherent interfaces based on atomistic simulations and dislocation theory. For example, of {111} interfaces between two face centered cubic (FCC) crystals, interface comprises of two stable structures (normal FCC stacking...

  • Study of the transition of the epitaxial Ge film from layer-to-layer to three-dimensional growth in heterostructures with strained SiGe sublayers. Drozdov, Yu. N.; Novikov, A. V.; Shaleev, M. V.; Yurasov, D. V. // Semiconductors;Apr2010, Vol. 44 Issue 4, p519 

    The results of the study of features of the Ge film transition from two- to three-dimensional growth in different SiGe/Si(001) heterostructures with buried stressed layers are presented. It is shown that deposition of a stressed planar SiGe layer results in a significant decrease in the critical...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics