TITLE

Continuous-wave laser action at λ=1064.3 nm in proton- and carbon-implanted Nd:YAG waveguides

AUTHOR(S)
Domenech, M.; Vázquez, G. V.; Cantelar, E.; Lifante, G.
PUB. DATE
November 2003
SOURCE
Applied Physics Letters;11/17/2003, Vol. 83 Issue 20, p4110
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
This work reports continuous laser oscillation at λ=1064.3 nm at room temperature in Nd:YAG planar waveguides fabricated by two different techniques: proton implantation with a multi-implant of energies around 1 MeV and carbon implantation with a single-implant at an energy of 7 MeV. Threshold powers of 11 and 22 mW and slope efficiencies of 7% and 9% were achieved in the proton- and carbon-implanted guides, respectively. The laser outputs show a very high stability operating in cw regime at room temperature. © 2003 American Institute of Physics.
ACCESSION #
11421611

 

Related Articles

  • Room-temperature continuous wave laser oscillations in Nd:YAG ceramic waveguides produced by carbon ion implantation. Tan, Y.; Zhang, C.; Chen, F.; Liu, F.-Q.; Jaque, D.; Lu, Q.-M. // Applied Physics B: Lasers & Optics;Jun2011, Vol. 103 Issue 4, p837 

    We report on the generation of continuous wave lasers at a wavelength of ∼1064 nm in a Nd:YAG ceramic waveguide at room temperature. The waveguide was fabricated by using 6 MeV carbon ion implantation at a fluence of 3×10 ions/cm. Laser operation has been realized with a slope...

  • Flux-grown Nd:YAG crystals make high-power microcavity laser. Hobbs, Jerry R. // Laser Focus World;Dec94, Vol. 30 Issue 12, p28 

    Reports on the single-frequency output power of 210 mW on 1.319 micrometers transition from flux-grown monolithic Nd-YAG crystal lasers. Performance of neodymium (Nd)-doped microcavity lasers; Variations of crystal temperature and pump power.

  • Beam stabilization improves Nd:YAG laser performance.  // Laser Focus World;Apr97, Vol. 33 Issue 4, p13 

    Focuses on the Spectra-Physics Lasers' BeamLok accessory which makes possible active beam stabilization for Nd:YAG lasers. Description of the device; Challenges in developing the device; Comment by Adrian Rowland of Spectra-Physics Lasers.

  • Periodically poled KTP efficiently frequency-doubles external-cavity Nd:YAG laser.  // Laser Focus World;May97, Vol. 33 Issue 5, p9 

    Reports that researchers from Soreq NRC and Tel Aviv University, Israel, have realized close to 70 percent efficiency in a single-pass, external-cavity, frequency-doubled Nd:YAG laser. Average output power; Conversion efficiency.

  • Laser-diode-pumped Cr[sup 4+] , Nd[sup 3+] :YAG self-Q-switched laser with high repetition rate and high stability. Hong, Z.; Zheng, H.; Chen, J.; Ge, J. // Applied Physics B: Lasers & Optics;2001, Vol. 73 Issue 3, p205 

    A diode end-pumped self Q-switched Cr[sup 4+] , Nd[sup 3+] : YAG laser was established with 30-ns pulse width (FWHM) and 0.5-μJ pulse energy output. In normal pulse pumping operation, the lasing threshold changed greatly from 122 mJ to 2.4 mJ as the pump pulse frequency varied from 1 Hz to...

  • Manufacturing breakthroughs made in YAG microchip lasers.  // Electronic Design;05/01/97, Vol. 45 Issue 9, p28 

    Reports on advances in the manufacturing process of yttrium-aluminum-garnet (YAG) microlasers. Production process for the microchip; Polishing of the rear face to eliminate deposits; Use of laser diode for pumping the microlaser.

  • Photoemission from diamond films illuminated by intense Nd:YAG laser harmonics. Boscolo, I.; Catani, L.; Cialdi, S.; Orlanducci, S.; M.Rossi, S.; Sessa, V.; Tazzioli, F.; Terranova, M.L.; Vicario, C. // Applied Physics A: Materials Science & Processing;2003, Vol. 77 Issue 6, p805 

    Photoemission from polycrystalline diamond films irradiated with the harmonics of a Nd:YAG laser indicates that the amorphous or quasi-amorphous zones (patches) of sp[SUP2]-C on the external surface of the diamond grains make a dominant contribution to the emission yield. This is deduced from:...

  • Parametric Study On The CW Nd: YAG Laser Cutting Quality Of 1.25 mm Ultra Low Carbon Steel Sheets Using O2 Assist Gas. Salem, Hanadi G.; Abbas, Wafaa A.; Mansour, Mohy S.; Badr, Yehia A. // AIP Conference Proceedings;2007, Vol. 888 Issue 1, p186 

    There are many non-linear interaction factors responsible for the performance of the laser cutting process. Identification of the dominant factors that significantly affect the cut quality is important. In the current research, the gas pressure, laser power and scanning speed were selected as...

  • Photodetachment effect in a radio frequency plasma in CF4. Jauberteau, J. L.; Meeusen, G. J.; Haverlag, M.; Kroesen, G. M. W.; de Hoog, F. J. // Applied Physics Letters;12/18/1989, Vol. 55 Issue 25, p2597 

    Experiments to study negative ion densities have been carried out using the photodetachment effect in a rf plasma in CF4. Electrons are detached from the negative ions under the influence of the pulse of a Nd:YAG laser. The induced increase of the electron density is measured as a function of...

Share

Read the Article

Courtesy of VIRGINIA BEACH PUBLIC LIBRARY AND SYSTEM

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics