TITLE

Determination of Enthalpy of Pyrolysis from DSC and Industrial Reactor Data: Case of Tires

AUTHOR(S)
Lanteigne, Jean-Remi; Laviolette, Jean-Philippe; Chaouki, Jamal
PUB. DATE
June 2015
SOURCE
Chemical Product & Process Modeling;Jun2015, Vol. 10 Issue 2, p97
SOURCE TYPE
Academic Journal
DOC. TYPE
Article
ABSTRACT
No abstract available.
ACCESSION #
102957240

 

Related Articles

  • Comparative study between SISCON and MATLAB in pyrolysis reactor identification. Azzouzi, Messaouda // Journal of Applied Functional Analysis;Apr2009, Vol. 4 Issue 2, p273 

    In this work, we have tried to identify a pyrolysis reactor; this type of reactor is widely used in petrochemical plants, especially in oil refineries; the analytical study was suggested to optimize the pyrolysis reactor operation and then to control it, to be as far away as possible so as not...

  • Assessment of polyamide-6 crystallinity by DSC. Millot, Coraline; Fillot, Louise-Anne; Lame, Olivier; Sotta, Paul; Seguela, Roland // Journal of Thermal Analysis & Calorimetry;Oct2015, Vol. 122 Issue 1, p307 

    This study addresses the question of the crystallinity determination of PA6 by means of DSC in the case when structural changes occur over a very large temperature domain during the heating scan. The temperature dependence of the melting enthalpy is then of crucial importance for determining the...

  • Measurement of reaction enthalpy during pressure oxidation of sulphide minerals. Bylina, I.; Trevani, L.; Mojumdar, S. C.; Tremaine, P.; Papangelakis, V. G. // Journal of Thermal Analysis & Calorimetry;Apr2009, Vol. 96 Issue 1, p117 

    A calorimetric method for determining the enthalpy of the aqueous oxidation of sulfide minerals at high temperatures and oxygen pressures has been developed and evaluated under conditions relevant to industrial pressure oxidation operations. This information is important for heat balance...

  • CALCULATION METHODS AND PROGNOSIS OF THE THERMODYNAMIC PROPERTIES. Baikusheva-Dimitrova, Ginka; Marinov, Valentin // Management & Education / Upravlenie i Obrazovanie;2013, Vol. 9 Issue 6, p33 

    Data on the standard enthalpy of formation of tellurites of rare earth elements are scarce and this determined the interest towards these studies. The present paper reports for studies and suggests four methods for calculation of the standard enthalpy of formation on the rare earths tellurites...

  • Thermochemistry of the pyridinium- and pyrrolidinium-based ionic liquids. Verevkin, Sergey; Ralys, Ricardas; Emel'yanenko, Vladimir; Zaitsau, Dzmitry; Schick, Christoph // Journal of Thermal Analysis & Calorimetry;Apr2013, Vol. 112 Issue 1, p353 

    We applied DSC for the determination of enthalpies of synthesis reactions of pyridinium- and pyrrolidinium-based ionic liquids (ILs) from pyridine (or N-methyl-pyrrolidine) and n-alkyl bromides (with n = 4, 5, 6, 7, and 8). The combination of reaction enthalpy measurements by DSC with modern...

  • Determination of specific heat capacity and standard molar combustion enthalpy of taurine by DSC. Han, Xue-Wei; Zhou, Cai-Rong; Shi, Xiao-Hua // Journal of Thermal Analysis & Calorimetry;Jul2012, Vol. 109 Issue 1, p441 

    Using XRY-1C calorimeter, the standard molar enthalpy of taurine was determined to be −2546.2 kJ mol . The reliability of the instrument used was tested by using naphthalene as reference material; and through comparing the molar combustion enthalpy of naphthalene measured with its standard...

  • Combustion and pyrolysis characteristics of tunçblek lignite. Elbeyli, İ. Y.; Piškin, S. // Journal of Thermal Analysis & Calorimetry;Mar2006, Vol. 83 Issue 3, p721 

    In this study, thermal characteristics and kinetic parameters of cleaned Tunçbilek lignite were determined by using a Setaram Labsys DTA/TG/DSC thermal analysis system both for combustion and pyrolysis reactions. Experiments were performed at a heating rate of 10°C min–1 under...

  • DSC Studies of rhododendron hybrids frost resistance. Swiderski, A.; Wojtal, A.; Muras, P.; Mikulko, A.; Wrobel, S.; Koloczek, H. // Journal of Thermal Analysis & Calorimetry;Mar2006, Vol. 83 Issue 3, p631 

    The DSC method was used to study phase transitions in Rhododendron L. leaf tissues caused by temperatures below the freezing point of water. The curves show several stages of water crystallisation, demonstrating that these processes do not occur simultaneously in various types of cell...

  • Heat capacities and thermodynamic properties of ( S)- tert-butyl 1-phenylethylcarbamate. Zeng, Ju-Lan; Yu, Sai-Bo; Tong, Bo; Sun, Li-Xian; Tan, Zhi-Cheng; Cao, Zhong; Yang, Dao-Wu; Zhang, Jing-Nan // Journal of Thermal Analysis & Calorimetry;Mar2011, Vol. 103 Issue 3, p1087 

    n N- tert-butyloxycarbonylated organic synthesis intermediate, ( S)- tert-butyl 1-phenylethylcarbamate, was prepared and investigated by means of differential scanning calorimetry (DSC) and thermogravimetry (TG). The molar heat capacities of ( S)- tert-butyl 1-phenylethylcarbamate were precisely...

  • Evaluation of errors in determination of DNA melting curve registered with differential scanning calorimetry. LANDO, D. Y.; GRIGORYAN, I. E.; FRIDMAN, A. S.; GALYUK, E. N.; DALYAN, Y. B.; HAROUTIUNIAN, S. G. // Ajastan Kensabanakan Handes;2013, Vol. 65 Issue 2, p6 

    The differential scanning calorimetry (DSC) is more sensitive than UV absorption spectrophotometry as a tool for the measurement of DNA melting curves. The advantage of DSC is a direct determination of differential melting curves (DMC) obtained without numerical differentiation. However, the...

Share

Read the Article

Courtesy of THE LIBRARY OF VIRGINIA

Sorry, but this item is not currently available from your library.

Try another library?
Sign out of this library

Other Topics